Husqvarna CTH180 XP 02764 owner manual Service and Adjustments, To Remove Mower See Fig

Page 22

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

•Depress clutch/brake pedal fully and set parking brake.

•Place motion control lever in neutral (N) position.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 24)

Mower will be easier to remove from the right side of trac- tor.

•Place attachment clutch control in “DISENGAGED” position.

•Move attachment lift lever forward to lower mower to its lowest position.

•Roll belt off clutch pulley.

•Disconnect anti-sway bar from chassis bracket by removing retainer spring.

•Disconnect suspension arms from rear deck brackets by removing retainer springs.

•Disconnect front links from deck by removing retainer springs.

•Raise lift lever to raise suspension arms. Slide mower out from under tractor.

IMPORTANT: IF AN ATTACHMENT OTHERTHANTHE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS.

TO INSTALL MOWER (See Fig. 24)

Be sure tractor is on level surface and mower suspension arms are raised with attachment lift control. Engage park- ing brake.

•Slide mower under tractor.

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

•Install belt into clutch pulley groove.

•Install left front link into the left hand front mower bracket (retain with single loop retainer springs as shown).

•Slide right side of mower back and install right front link into right hand front mower bracket (retain with single loop retainer springs).

•Place the suspension arms on mower pins, if necessary, rock and raise front of mower to align mower pins with the holes in suspension arms. Retain with double loop retainer spring, loop down as shown.

•Connect anti-sway bar to chassis bracket under left footrest and retain with double loop retainer spring.

•Raise deck to highest position.

RETAINER

 

SPRING

CLUTCH PULLEY

SUSPENTION

ARMS

 

 

FRONT LINKS

RETAINER

SPRINGS

RETAINER SPRING

ANTI SWAY

BAR

FIG. 24

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents CTH180 XP General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Unassembled Parts Steering Wheel SeatTo Remove Tractor from CAR- TON AssemblyTools Required for Assembly Before Removing Tractor from SkidInstall Seat See Fig ControlsTo Install Bagger Components to Tractor See Figs A-4D To Assemble Bagger See FigsHorizontal Adjustment To Assemble and Install Mulcher Plug See FigBagger Adjustment See Fig Vertical AdjustmentCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Transport See FigsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Mulching Mowing TipsBagging See To Dump Bagger SeeTo Convert Mower See General Recommendations MaintenanceLubrication Chart Before Each USETractor Blade CareEngine Cleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Replace Mower Blade Drive Belt See Fig To Check and Adjust Brake See FigTo Replace Motion Drive Belt See Fig Transaxle Motion Control Lever Neutral ADJUSTMENTSee Fig To Adjust Steering Wheel AlignmentTransmission REMOVAL/REPLACEMENT Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Carburetor Interlocks and RelaysFuel System StorageOther Engine OILTroubleshooting Points With attachment clutch Service Notes Schematic TRACTOR- -MODEL NO. CTH180 XP HAUCT18H42G, Product no 17Electrical KEY Part Description 213 Chassis and Enclosures 817 00Drive Repair Parts Steering Assembly 532 19 Steering Wheel Seat Assembly KEY Part Description KEY Part NO. noDecals Wheels & TiresEngine Optional EquipmentMower Lift Mower Repair Parts Bagger Warranty Statement Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX
Top Page Image Contents