98 Hardware Maintenanc e Manual: IBM PC Server/Enterprise Racks
Installing a large server
Use the following general procedure to install a large server in your rack cabinet:
Figure 43. Installing a large server
1. See the server documentation for d etailed installation and configuration
information.
2. Use the template and rack mounting instruc tions that come with your server to
determine where to install clip nuts.
3. Install the slide rails and cable-management arm that come with your se rver,
using the provided screws and clip nuts.
Note: If required, adjust the length of the slide rails to fit the depth of your rack
cabinet.
4. Install the server handles; then, lift the server and place it on the extended slide
rails.
5. Attach the server to the slide rails with the provided screws; then, remove the
server handles and slide the server into the rack cabinet.
6. See your server documentation for information on how to connect power and
other device cables.
Cable-management arm
Rear of rail
Front of rail
Server rail screws
Server handles