IBM 9QS, 9TX, 9TS, 9QX, 900, 4SB, 4SA, 42P, 42X, 200, 42E, 42S, 4QS Sliding trays, Single latch rail tray

Ground

Wire

Power

Plug

Sliding trays

Models 4QS and 4QX come with either single latch slide rails or dual latch slide rails. Single latch slide rails have a front latch release on the right rail only. Dual latch slide rails have a front latch release on both rails. The slide rail FRU number for the 24-inch rack replaces the single latch slide rail with the dual latch slide rail.

Note: If a server is installed on a tray being removed, first remove the server.

Single latch rail tray

To remove a sliding tray with single latch rails:

1.Power-off the rack.

2.Open the rear door of the rack cabinet and remove the pin 1 that secures the sliding tray to the cable management arm

3.Loosen the thumbscrews 2 on the sliding tray and fully extend the sliding tray.

4.Use a 3/32-inch allen wrench to remove the five screws 3 from the left side of the sliding tray.

5.Lift the rear locking tab 4 and push the sliding tray approximately two inches into the cabinet.

6.Release the forward locking tab 5. Then, while holding the sliding tray in place, use your other hand to grasp the outside sliding rail 6 and push it into the rack cabinet until it disconnects from the sliding tray.

Type 9306 Models 4QS, 4QX, 9QS, 9QX, 9TS, 9TX 9