Figure 16. Storing the power supply and routing cables
8.Connect the power supply to the monitor and route the cable under the tab near
the top of the monitor stand 1 ; then, secure the power cable with the cable clamp you removed from the original stand and coil excess cable inside the monitor stand.
9.Connect the monitor signal cable to the monitor and route it under the tab in the bottom of the monitor stand c2dand out the back of the stand through the hole provided.
10.Replace the monitor stand over c1d.
Figure 17. Installing the cable cover, hinge cover, and stand cover
11.Snap the new hinge cover c2dinto place over the hinge assembly.
Note: Be sure to use the new hinge cover that comes with the Flat Panel Monitor Rack Mount Kit because it has deeper grooves to accommodate the new hinge assembly.
New hinge cover | Old hinge cover |
12.Snap the cable cover c3dinto place on the back of the flat panel monitor.
13.Fold the flat panel monitor down until it rests on the rubber bumpers; then, gently push back and remove the small cable exit cover c1don the monitor stand.
