Husqvarna CTH180 XP 02764 owner manual To Dump Bagger See, Bagging See, To Convert Mower See

Page 17

OPERATION

TO DUMP BAGGER (See Fig.16)

Your tractor is equipped with a Dump Bag Alarm.To turn off the alarm disengage the attachment clutch switch.

Position tractor in location you wish to dump bagger.

Place motion control lever in Neutral position and set parking brake.

Raise dump handle to its highest position. Pull handle forward to raise bagger and dump clippings.

To continue mowing, be sure bagger is down and in proper operating position which will allow mower to operate.

MULCHER PLUG

31 23 0

FIG. 17

BAGGING (See Fig.18)

Place deck into the high cut position.

Remove the rear discharge defl ector or mulching plug.

Insert the discharge chute into the opening in the backplate and onto the mower deck adaptor.

Attach the chute to the tractor by hooking the two straps to the flange of the chute.

NOTE: The strap hook must go through the discharge chute only. Do not allow the hook to enter the slot in the tractor back plate. If it does, the discharge chute will not fl oat with the mower deck when mowing on uneven terrain.

Install bagger onto tractor.

DISCHARGE

CHUTE

HOOK

02207

02306

BACKPLATE SLOT

FIG. 16

TO CONVERT MOWER (See Fig.17)

(Converting to mulching or rear discharging will require a mulcher plug and discharge deflector)

MULCHING (Requires mulcher plug)

Place deck into the high cut position.

Remove bagger or optional rear discharge deflector.

Unhook the two (2) straps and remove discharge chute

Insert mulcher plug and handle assembly through back

plate and onto the mower deck chute adaptor.

Secure the plug assembly by connecting the two straps over the handle and hook into the holes provided .

Replace bagger or optional rear discharge deflector to allow mower to operate.

You are now ready to begin mulching.

FIG. 18

REAR DISCHARGING (optional accessory required)

Place deck into the high cut position.

Remove bagger and mulching plug (if installed).

Depress rear door and install discharge chute through opening in backplate and slide over deck adaptor.

Attach the chute by hooking the two straps into the holes in the flange of the chute.

NOTE: The strap hook must go through the discharge chute only. Do not allow the hook to enter the slot in the tractor back plate. If it does, the discharge chute will not fl oat with the mower deck when mowing on uneven terrain.

Install the discharge deflector to the backplate by screw- ing the four (4) wing screws into the threaded inserts located in the backplate.

Tighten the wing screws securely.

17

Image 17
Contents CTH180 XP Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationIV. Towing ServiceIII. Children Table of Contents Steering Wheel Seat Unassembled PartsTools Required for Assembly AssemblyTo Remove Tractor from CAR- TON Before Removing Tractor from SkidControls Install Seat See FigTo Assemble Bagger See Figs To Install Bagger Components to Tractor See Figs A-4DBagger Adjustment See Fig To Assemble and Install Mulcher Plug See FigHorizontal Adjustment Vertical AdjustmentCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigTo Operate on Hills To Transport See FigsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigMulching Mowing Tips Mowing TipsTo Convert Mower See To Dump Bagger SeeBagging See Lubrication Chart MaintenanceGeneral Recommendations Before Each USEBlade Care TractorEngine Cleaning To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTo Replace Mower Blade Drive Belt See Fig Transmission REMOVAL/REPLACEMENT To Adjust Steering Wheel AlignmentTransaxle Motion Control Lever Neutral ADJUSTMENTSee Fig Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Replace Headlight Bulb Interlocks and RelaysOther StorageFuel System Engine OILTroubleshooting Points With attachment clutch Service Notes TRACTOR- -MODEL NO. CTH180 XP HAUCT18H42G, Product no 17 SchematicElectrical KEY Part Description 213 817 00 Chassis and EnclosuresDrive Repair Parts Steering Assembly 532 19 Steering Wheel KEY Part Description KEY Part NO. no Seat AssemblyWheels & Tires DecalsOptional Equipment EngineMower Lift Mower Repair Parts Bagger Warranty Statement Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation