Hustler Turf 3700, 3500 owner manual Park brake lever Release button Differential lock pedal

C Park brake lever

Release button

Figure 3-6

DDifferential lock pedal

Figure 3-7

variable from zero to full rated speed in each range. The ground speed is controlled by these pedals. Depress the forward travel pedal to progressively increase forward speed. For reverse travel, depress the reverse travel pedal. NOTE: These pedals must be in neutral (not depressed) to start the engine.

F.Cruise control switch (Figure 3-8) — Used to maintain a constant forward speed. After attaining the desired speed with the forward travel pedal, put the switch to the “ON “position, and the unit will maintain the set speed when the pedal is released.

To cancel the speed setting or stop the unit, put the cruise control switch to the “OFF” position or firmly depress the master brake pedal.

WARNING: To avoid injury, the cruise control switch should not be put in the “ON” position when operating at transport speed or when in reverse.

F

Figure 3-8

GTransmission selector lever shown in the Automatic AWD position

Figure 3-9

High range Low range

GTransmission selector lever shown in the locked AWD position

Figure 3-10

G.Transmission Selector lever (Figure 3-9 & Figure 3- 10) — The Range Selection and the All Wheel Drive (AWD) Selection are controlled by the Transmission Selector lever. This lever can only be shifted when the HST foot pedal is in the Neutral position

When the Transmission Selector lever is located in the inside slot, the tractor will run in Automatic AWD mode. When the lever is in this position there are three settings: High range (H), Low range (L) and Neutral.

109627_0910 3-5