Hustler Turf 3500, 3700 Engine air filter, Recommended service procedure, Overservicing

Page 36

certain period of time is required before the engine oil completely flows down from the oil filler to the crankcase.

4.Check the oil level, accounting for the higher oil level due to the oil filter oil capacity.

Engine oil filler

Dipstick

Figure 4-13

Engine oil

fill cap

Figure 4-14

Engine air filter

Perform engine air filter maintenance per the Service Interval chart shown elsewhere in this manual.

A specially designed dry filter is standard equipment on these tractors and supplies clean combustion air to the engine. Figure 4-16 Change the filter whenever the Air Cleaner Restriction Warning Light comes on. Figure 3-1

These units are equipped with a safety filter. The filter element slides over the safety filter. NOTE: For maximum

Engine oil drain

Figure 4-15

engine protection and air cleaner service life, install a new inner safety element every third primary element change or after every 1000 hours of operation, whichever comes first.

NOTE: The safety filter does not require servicing unless it becomes contaminated with dirt or moisture.

Recommended service procedure

1.Release clamps and remove element. Clean the canister with a damp cloth.

2.Before installing a new element, inspect it by placing a bright light inside and rotate the element slowly, looking for any holes or tears in the paper. Also check gaskets for cuts or tears. Do not attempt to use a damaged element which will allow abrasive particles to enter the engine.

3.Install the new element and reinstall the dust cup. Make sure it seals all the way around the air cleaner body, then tighten the clamps.

4.Check all fittings and clamps periodically for tightness and inspect hoses for holes or cracks.

5.Periodically check the intake hose for signs of ingested dust. Locate and repair the source of ingested dirt.

6.Never operate a machine without an air filter installed.

Overservicing

Overservicing occurs when an air filter element is removed for cleaning or replacement before it is necessary. Each time the filter is removed a small amount of dirt and dust could fall in the intake system. This accumulated dirt can cause a dusted engine. It only takes a few grams of ingested dirt over the normal service life of an engine to cause a dusted engine.

Do not clean element, replace with a new element only. Cleaning used air filter elements, through improper cleaning procedures, can get dust on the inside of the filter causing dirt ingestion and engine failure.

4-8

109627_0910

Image 36
Contents Box Hesston, Kansas 67062-2097 1096270910 General Information 1096270910 WHO Must Perform the Warranty Service 3500/3700 TractorsWarranty Registration Safety Precautions Safety and Instruction DecalsFluid under pressure Decals before attempting to operate or Service this machine 601415415 International Symbols OFF1096270910 Slope Guide 1096270910 Operation Safe Operating PracticesOperation Using a ramp Slope OperationSwitches ChildrenInstrument Panel Controls Park brake lever Release button Differential lock pedal Seat adjustment Steering wheel adjustmentSafety start interlock system To inspect the safety start interlock system PTO stop systemTo inspect the PTO stop system Engine starting Warm weather startingCold weather starting Starting the engine with jumper cablesStopping the engine Operating the hydrostatic transmissionEngine warm up Hydrostatic transmissionAuxiliary hydraulic valve kit optional Rear counter-balance weights Roll Over Protective StructurePossible damage to the Rops Driving the tractor Operating suggestions1096270910 Maintenance & Adjustments ServiceSafe Servicing Practices IntroductionService access Torque valuesTires LubricationAlternator Fuse blockReplacement bulb Replacement bulbsFusible link Head lampFuel system Diesel fuel Refueling the TractorEngine oil and filter Recommended service procedure Engine air filterOverservicing Cooling system Checking the coolant levelDraining and flushing the cooling system To drain the cooling system Fan beltTransmission, front axle and hydraulic system Checking Oil LevelChanging Oil & Filters PTO control lever adjustment Change the oil every 500 hours or annuallyGeneral engine maintenance Park brake adjustment Rear wheel toe adjustment Brake linkage Front clevis Jam nut 1096270910 3500/3700 Maintenance Schedule Refer to Figures 4-39 Intervals IndicatedMaintenance Locator Chart Maintenance Locator Chart 1096270910 Storage Product LiteraturePreparation of engine for storage New season preparation1096270910 Rear wheel toe adjustment Index1096270910