Hustler Turf 3500, 3700 Fusible link, Head lamp, Replacement bulb, Instrument panel light

Alternator

				Figure 4-3
		Fuse Size			Circuit protected
1		20 amp		Spare
2		20 amp		Auxiliary P.T.O., Work lamp (opt), back
				buzzer (opt)
3		20 amp		Auxiliary
4		10 amp		Spare
5		10 amp		Head lamp, meter back light, stop
				solenoid, safety switch, starter, cruise
				control (opt)
6		10 amp		Temperature gauge, fuel gauge, fuel
				pump, monitor lamp,
				Alarm buzzer & relay
					’“”
	Fuse block		‘

Figure 4-4

Fusible link

A fusible link wire is used to protect the mower’s entire electrical system. If too much amperage passes through this wire it will melt down so that it will no longer allow current to pass (similar to the way a fuse works). The fusible link wire is a red wire that goes from the starter terminal to a connector

that links into the main wiring harness.

To replace the fusible link wire (Figure 4-5):

1.Order Hustler part number 385603370.

2.Disconnect the negative battery cable from the battery.

3.Unplug the connector linking the wire to the main wiring harness.

4.Remove the old fusible link wire from the starter terminal.

5.Replace the old fusible link wire with a new one-first attaching to starter terminal, and then connecting into the main wire harness.

IMPORTANT: Always replace the fusible link wire with the appropriate fusible link wire for this tractor.

Fusible link

Figure 4-5

Head lamp

If a head lamp fails to operate, the bulb must be replaced. To change the bulb:

1.Pull the lower cover frontward and remove it. Figure 4- 6

2.Turn the socket counterclockwise and remove the socket from the headlamp housing.

3.Remove the bulb. Figure 4-7

4.Install a new bulb in the socket and install the socket with bulb in the housing.

5.Install the front cover.

Replacement bulb:

Head Lamp Bulb Type . . . . JIS S25 BA15 12V 23W

Instrument panel light

To change a burned out instrument bulb:

1.Pull the lower cover frontward and remove it. Figure 4- 7

2.Remove the four screws that connect the front cover to the dashboard. Figure 4-8

3.Remove the front cover of the dashboard. Figure 4-8

4.Turn the burned out bulb together with the socket half a turn counterclockwise and pull it out. Figure 4-9

5.Replace the bulb with new one and return the bulb and socket to the original place.

6.Re-attach the front cover and lower cover.

Replacement bulbs:

Indicator Bulb Type. . . . . . . JIS T6.4 14V 3W (Qty 5)

4-4 109627_0910