Husqvarna 1153191-26 manual Basic working techniques

Page 10

SAFETY INSTRUCTIONS

Basic working techniques

WARNING! Watch out for thrown objects.

! Always wear eye protection. Stones, rubbish, etc. can be thrown up into the eyes causing blindness or serious injury. Keep unauthorised persons at a distance. Children, animals, onlookers and helpers should be kept outside the safety zone of 15 m. Stop the machine immediately if anyone approaches.

!

WARNING! Always stop the engine

before cleaning.

 

• The speed of the air jet is regulated by means of the throttle. Select the speed best suited for respective tasks. You can set the throttle position using the ”stop switch” and by doing so not need to hold your finger on the throttle all the time you are using the blower. Full throttle is obtained when the control is held back fully.

Check that the air intake is not blocked, for example, by leaves or rubbish. A clogged air intake reduces the machine’s blowing capacity and increases the engine’s working temperature, which can result in engine failure. Stop the engine and remove the object.

Be aware of the wind direction. Work with the wind to make your work easier.

Using the blower to move large piles is time consuming and creates unnecessary noise.

When work is finished the machine should be stored vertically.

10 – English

Image 10
Contents 356BTX-series Introduction Dear CustomerKEY to Symbols SymbolsContents Stop switch Safety InstructionsMachine′s safety equipment Personal protective equipmentVibration damping system MufflerGeneral safety precautions GeneralStarting Fuel safetyAdjusting the harness Transport and storageBasic safety rules General working instructionsBasic working techniques What is WHAT? What is what on the blower?Assembly Assembling the blow pipe and control handleHandlebar AccessoriesFlat nozzle Petrol Fuel HandlingFuel Two-stroke oilFuelling Cold engine Starting and StoppingStarting and stopping Warm engineCarburettor MaintenanceMuffler Spark plug Cooling systemAir filter Oiling the air filter Cleaning the air filterMust always be replaced Weekly maintenance Maintenance scheduleDaily maintenance Monthly maintenanceTechnical Data Technical dataEC-declaration of conformity Applies to Europe only EN ISO 12100-2/A12009, Cispr 122001, EN155032009Page Original instructions 1153191-26