Husqvarna SG13A, SG13, SG13/968999353 manual Fuel system

Page 12

SAFETY INSTRUCTIONS

Fuel system

WARNING!

Gasoline and gasoline fumes are poisonous and extremely flammable. Be especially careful when handling gasoline, as carelessness can result in personal injury or fire.

Only store fuel in containers approved for that purpose.

Never remove the fuel cap and fill the fuel tank when the engine is running.

Always stop the engine when refueling.

Do not smoke when filling the gasoline tank and do not pour gasoline in the vicinity of sparks or open flame.

Never fill the fuel tank indoors.

8011-205chg

Never fill the fuel tank indoors.

Before starting the machine after refueling, it should be moved at least 10 feet (3 M) from the location where it was filled.

Turn off the fuel supply for storage or transport.

If leaks arise in the fuel system, the engine must not be started until the problem has been resolved.

1

8011-186

Close the fuel valve.

1. FUEL VALVE

• Check the fuel level before each use and leave space for the fuel to expand, because the heat from the engine and the sun can otherwise cause the fuel to expand and overflow.

• Avoid overfilling. If you spill gasoline on the machine, wipe up the spill and wait until it has evaporated before starting the engine. If you spill gasoline on your clothing, change your clothing.

8011-222chg

Fueling always poses an element of risk.

12

Image 12
Contents Operator’s Manual Models Manual no REV 12/01/05Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Symbols and Decals Decals and machine-bound instructionsLocation of decals Translation of instructions Decal Important informationDecal Safety Instructions General useSafety Instructions Preparations Operating Movement/Transport StorageChildren Fuel system Maintenance Protective Equipment Personal equipmentSET-UP Equipment set-upHair PIN Engine Throttle Control Lever Throttle Cable Controls PresentationMain components and operating controls Engine Throttle12 11 Starter Starter handleFuel valve Choke controlSpark plug MufflerOil dipstick Oil drainageFuel tank FuelingCentrifugal clutch Dead man’s grip barOn/Off Engine switch on the panel Adjustment bar for the handleBrake Never operate a machine with a defective brakeOperation Starting the engineEngine switch on the handle Dead man’s grip barStarter handle Engine switch Normal shutdownShutdown in emergency situations BrakeBefore you start Using your stump grinder 8011-202chg Shut off the machine when you are done Operating on hillsTransport Maintenance Maintenance scheduleCleaning the cyclone filter Replacing the air filter Cleaning the sludge reservoir Idle adjustmentIgnition system Fitting the wrong spark plug type can damage the engineAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Adjusting the brake Cleaning and washingTwo minute rule Lubrication Engine oil Checking the engine’s oil levelRight wheel Throttle cableTroubleshooting Symptom Cause ActionProblem Possible solutions Service StorageWinter storage Technical Data ModelWiring Diagram Service Journal Delivery serviceService Journal