Husqvarna SG13/968999353, SG13A, SG13 manual Engine Throttle Control Lever Throttle Cable

Page 17

SET-UP

14.Insert “L” end of throttle cable into the outside hole of the engine throttle control lever. Figure 7.

15.Attach the throttle cable to the engine using the double wire clamp removed in step nine. Figure 8.

16.Test throttle control by pulling back throttle handle on console. Throttle arm on engine should be pushed completely forward. Cable should not slip in clamp when doing this test.

17.Test proper wire length by pulling on the handle adjustment lever and raising and lowering the handle to maximum position without any pull on harness.

18.Reattach air cleaner to engine.

19.Unit is now ready to be removed from pallet.

1

2

FORWARD

FIGURE 7

1.ENGINE THROTTLE CONTROL LEVER

2.THROTTLE CABLE

1

FIGURE 8

1. THROTTLE CABLE

17

Image 17

Contents Manual no REV 12/01/05 Operator’s Manual ModelsHusqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Decals and machine-bound instructions Symbols and DecalsDecal Location of decals Translation of instructionsDecal Important information General use Safety InstructionsSafety Instructions Preparations Operating Children Movement/TransportStorage Fuel system Maintenance Personal equipment Protective EquipmentEquipment set-up SET-UPHair PIN Engine Throttle Control Lever Throttle Cable Main components and operating controls ControlsPresentation 12 11 EngineThrottle Starter handle StarterFuel valve Choke controlMuffler Spark plugOil dipstick Oil drainageFueling Fuel tankCentrifugal clutch Dead man’s grip barAdjustment bar for the handle On/Off Engine switch on the panelBrake Never operate a machine with a defective brakeStarting the engine OperationStarter handle Engine switch on the handleDead man’s grip bar Normal shutdown Engine switchShutdown in emergency situations BrakeBefore you start Using your stump grinder 8011-202chg Transport Shut off the machine when you are doneOperating on hills Maintenance schedule MaintenanceCleaning the cyclone filter Replacing the air filter Idle adjustment Cleaning the sludge reservoirFitting the wrong spark plug type can damage the engine Ignition systemAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Two minute rule Adjusting the brakeCleaning and washing Lubrication Checking the engine’s oil level Engine oilThrottle cable Right wheelSymptom Cause Action TroubleshootingProblem Possible solutions Winter storage ServiceStorage Model Technical DataWiring Diagram Delivery service Service JournalService Journal