Husqvarna SG13/968999353, SG13A, SG13 manual 8011-202chg

Page 29

OPERATION

5.Tilt the machine on its wheels, lifting the cutting

wheel off the ground.

8011-202chg

6.Hold in the dead man’s grip bar and start the engine.

7.Allow the engine to warm up for two minutes at idle before grinding.

8. Set the throttle to FAST to ENGAGE clutch.

IMPORTANT INFORMATION

If the cutting wheel is too low, the machine may start to “climb” over the stump and become unstable.

9.Place the middle of the cutting wheel approximately one inch (2.5 cm) above and 3/4 to 1 1/2 inches (2-4 cm) into the stump.

10.Place the cutting wheel in the upper front edge of the stump. Swing the cutting wheel from side to side while lowering it about one inch (2.5 cm) after each pass until the front edge of the stump is gone.

8011-127

8011-185

8011-203

29

Image 29

Contents Manual no REV 12/01/05 Operator’s Manual ModelsHusqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Decals and machine-bound instructions Symbols and DecalsDecal Location of decals Translation of instructionsDecal Important information General use Safety InstructionsSafety Instructions Preparations Operating Children Movement/TransportStorage Fuel system Maintenance Personal equipment Protective EquipmentEquipment set-up SET-UPHair PIN Engine Throttle Control Lever Throttle Cable Main components and operating controls ControlsPresentation 12 11 EngineThrottle Starter handle StarterFuel valve Choke controlMuffler Spark plugOil dipstick Oil drainageFueling Fuel tankCentrifugal clutch Dead man’s grip barAdjustment bar for the handle On/Off Engine switch on the panelBrake Never operate a machine with a defective brakeStarting the engine OperationStarter handle Engine switch on the handleDead man’s grip bar Normal shutdown Engine switchShutdown in emergency situations BrakeBefore you start Using your stump grinder 8011-202chg Transport Shut off the machine when you are doneOperating on hills Maintenance schedule MaintenanceCleaning the cyclone filter Replacing the air filter Idle adjustment Cleaning the sludge reservoirFitting the wrong spark plug type can damage the engine Ignition systemAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Two minute rule Adjusting the brakeCleaning and washing Lubrication Checking the engine’s oil level Engine oilThrottle cable Right wheelSymptom Cause Action TroubleshootingProblem Possible solutions Winter storage ServiceStorage Model Technical DataWiring Diagram Delivery service Service JournalService Journal