Husqvarna SG13A, SG13, SG13/968999353 manual Operation, Starting the engine

Page 24

OPERATION

Starting the engine

Check that all daily maintenance as described in the maintenance schedule has been performed. Check that there is sufficient fuel in the tank.

Fuel valve

Open the fuel valve. Place the lever all the way to the right.

FUEL VALVE

8011-182

Choke control

When starting the engine warm, the lever should be in the right position; see the illustration.

When starting the engine cold or partially warm, place the lever completely or partly to the left.

Move the lever back to the right once the engine starts. When the engine is cold, it may be best to move the lever back in several stages. Find the position where the engine runs smoothly.

Throttle

Set the throttle on the handle to the SLOW(START)/ DISENGAGE position.

CHOKE

CONTROL

8011-183

.

Engine switch on the engine

Swtich on engine is disconnected, use engine switch on handlebar.

OFF

ON

8011-071

24

Image 24

Contents Operator’s Manual Models Manual no REV 12/01/05Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Symbols and Decals Decals and machine-bound instructionsLocation of decals Translation of instructions Decal Important informationDecal Safety Instructions General useSafety Instructions Preparations Operating Movement/Transport StorageChildren Fuel system Maintenance Protective Equipment Personal equipmentSET-UP Equipment set-upHair PIN Engine Throttle Control Lever Throttle Cable Controls PresentationMain components and operating controls Engine Throttle12 11 Starter Starter handleFuel valve Choke controlSpark plug MufflerOil dipstick Oil drainageFuel tank FuelingCentrifugal clutch Dead man’s grip barOn/Off Engine switch on the panel Adjustment bar for the handleBrake Never operate a machine with a defective brakeOperation Starting the engineEngine switch on the handle Dead man’s grip barStarter handle Engine switch Normal shutdownShutdown in emergency situations BrakeBefore you start Using your stump grinder 8011-202chg Shut off the machine when you are done Operating on hillsTransport Maintenance Maintenance scheduleCleaning the cyclone filter Replacing the air filter Cleaning the sludge reservoir Idle adjustmentIgnition system Fitting the wrong spark plug type can damage the engineAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Adjusting the brake Cleaning and washingTwo minute rule Lubrication Engine oil Checking the engine’s oil levelRight wheel Throttle cableTroubleshooting Symptom Cause ActionProblem Possible solutions Service StorageWinter storage Technical Data ModelWiring Diagram Service Journal Delivery serviceService Journal