Husqvarna 53 5RJ manual Assembly, Fitting the J-handle, Assembling the cutting equipment

Page 12

ASSEMBLY

Fitting the J-handle

•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.

Assembling the cutting equipment

•Slide the spacer into the slot in the loop handle.

•Fit the nut, knob and screw. Do not overtighten.

•Attach the J-handle to the loop handle using the three screws, as shown.

!

WARNING!

When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting

•Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.

WARNING! Only grass blades/grass

! cutters or trimmer heads/plastic blades may be used when the J-handle is fitted. Saw blades must never be used with the J-handle.

! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

Fitting the guard extension

CAUTION! The guard extension shall always be fitted when using the trimmer head/plastic blades and combination guard. The guard extension shall always be removed when using the grass blade and combination guard.

Enter the guard extension guide in the slot of the combination guard. Then click the guard extension into position on the guard with the four quick-fasteners.

12 – English

Page 11 Page 13
Image 12
Page 11 Page 13
Contents 535RJ KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what on the brush cutter?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system MufflerLocking nut Cutting equipment Cutting equipmentSharpening grass cutters and grass blades Trimmer head Assembly Fitting the J-handleAssembling the cutting equipment Fitting the guard extensionFitting a blade guard, grass blade and grass cutter Fitting other guards and cutting attachmentsAssembly Fuel safety Fuel HandlingFuel Fuelling MixingStarting and Stopping Check before startingStarting and stopping StartingStopping Basic safety rules Working TechniquesGeneral working instructions Grass clearing using a grass blade Basic working techniquesGrass trimming with a trimmer head TrimmingCutting SweepingMaintenance CarburettorMuffler Cooling system Bevel gearAir filter Cleaning the air filter Spark plugOiling the air filter Maintenance Maintenance schedule Maintenance Daily Weekly MonthlyTechnical data Approved accessories Type Cutting attachment guard, Art. no EC-declaration of conformity Applies to Europe onlyPage S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Page Page Original instructions 1154107-26
Top Page Image Contents