Husqvarna 53 5RJ manual Fitting a blade guard, grass blade and grass cutter

Page 13

ASSEMBLY

The guard extension is removed easily using the spark plug spanner, see illustration.

Fitting a blade guard, grass blade and grass cutter

the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).

A

A

GF

E

D

B

C

Fitting other guards and cutting attachments

•Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. CAUTION! Ensure that the guard extension is fitted.

Hang the trimmer guard/combination guard (A) on the two hooks on the plate holder (M). Bend the guard around the shaft and tighten it with the bolt (L) on the opposite side of the shaft. Use the locking pin (C). Place the locking pin in the groove on the screw head and tighten. See diagram.

•Hook the blade guard/combination guard (A) onto the fitting on the shaft and secure with the bolt. CAUTION! Ensure that the guard extension is removed.

Use the recommended blade guard. See the Technical data section.

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•Place the blade (D), support cup (E) and support flange (F) on the output shaft.

•Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn

L

M

C

A

•Fit the drive disc (B) on the output shaft.

H

BA

C

M L

• Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

• Insert the locking pin (C) in the hole to lock the shaft.

English – 13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 535RJ Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what on the brush cutter? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentCutting attachment guard Stop switchVibration damping system MufflerLocking nut Cutting equipment Cutting equipmentSharpening grass cutters and grass blades Trimmer head Fitting the J-handle AssemblyAssembling the cutting equipment Fitting the guard extensionFitting other guards and cutting attachments Fitting a blade guard, grass blade and grass cutterAssembly Fuel Handling Fuel safetyFuel Mixing FuellingCheck before starting Starting and StoppingStarting and stopping StartingStopping Working Techniques Basic safety rulesGeneral working instructions Basic working techniques Grass clearing using a grass bladeGrass trimming with a trimmer head TrimmingSweeping CuttingCarburettor MaintenanceMuffler Bevel gear Cooling systemAir filter Spark plug Cleaning the air filterOiling the air filter Maintenance Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data EC-declaration of conformity Applies to Europe only Approved accessories Type Cutting attachment guard, Art. noPage S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Page Page Original instructions 1154107-26
Top Page Image Contents