Husqvarna 53 5RJ manual Spark plug, Cleaning the air filter, Oiling the air filter

Page 24

MAINTENANCE

Unnecessary wear to engine parts.

Excessive fuel consumption.

Clean the filter every 25 hours, or more regularly if conditions are exceptionally dusty.

Cleaning the air filter

Remove the air filter cover and take out the filter. Wash it clean in warm, soapy water. Ensure that the filter is dry before refitting it.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter must always be replaced.

If the machine is used in dusty conditions the air filter should be soaked in oil. See instructions under the heading Oiling the air filter.

Oiling the air filter

Always use special filter oil. Filter oil contains a solvent to make it spread evenly through the filter. You should therefore avoid skin contact.

Put the filter in a plastic bag and pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter to the machine. Never use common engine oil. This would drain through the filter quite quickly and collect in the bottom.

Spark plug

The spark plug condition is influenced by:

Incorrect carburettor adjustment.

An incorrect fuel mixture (too much or incorrect type of oil).

A dirty air filter.

These factors cause deposits on the spark plug electrodes, which may result in operating problems and starting difficulties.

24 – English

Image 24
Contents 535RJ KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what on the brush cutter?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system MufflerLocking nut Cutting equipment Cutting equipmentSharpening grass cutters and grass blades Trimmer head Assembly Fitting the J-handleAssembling the cutting equipment Fitting the guard extensionFitting a blade guard, grass blade and grass cutter Fitting other guards and cutting attachmentsAssembly Fuel safety Fuel HandlingFuel Fuelling MixingStarting and Stopping Check before startingStarting and stopping StartingStopping Basic safety rules Working TechniquesGeneral working instructions Grass clearing using a grass blade Basic working techniquesGrass trimming with a trimmer head TrimmingCutting SweepingMaintenance CarburettorMuffler Cooling system Bevel gearAir filter Cleaning the air filter Spark plugOiling the air filter Maintenance Maintenance schedule Maintenance Daily Weekly MonthlyTechnical data Approved accessories Type Cutting attachment guard, Art. no EC-declaration of conformity Applies to Europe onlyPage S35 2,7mm 095-.106 25 m 15 cm T35, T35x T45, T45x Page Page Original instructions 1154107-26