
ASSEMBLY
connecting the high pressure hose to the pump
See Figure 9.
After the high pressure hose has been uncoiled and attached to the spray wand:
n Pull back and hold the
n Insert the nozzle on the end of the
n Release the collar.
n Pull on the hose to be certain it is properly secured.
high pressure
hose
connecting the garden hose to the pressure washer
See Figure 10.
Water supply must come from a home water main. NEVER use hot water or water from pools, lakes, etc. Before connecting the garden hose to the pressure washer:
nRun water through the hose for 30 seconds to clean any
debris from the hose.
n Inspect the screen in the water intake.
nIf the screen is damaged, do not use the machine until the screen has been replaced.
nIf the screen is dirty, clean it before connecting the garden
hose to the machine.
To connect the garden hose to the machine:
nUncoil the garden hose.
NOTE: There must be a minimum of 10 feet of unrestricted hose between the pressure washer intake and the hose faucet or shut off valve (such as a “Y” shut off connector).
nWith the hose faucet turned completely off, attach the end of the garden hose to the water intake. Tighten by hand.
|
|
collar | Fig. 9 |
| |
| garden |
| hose |
screen 




Fig. 10
OPERATION
WARNING:
Do not allow familiarity with tools to make you care- less. Remember that a careless fraction of a second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recom- mended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury.
WARNING:
Do not direct discharge stream at persons. Failure to heed this warning could result in serious injury.
12