troubleshooting
Problem |
| Cause |
| Solution |
|
|
|
|
|
Engine fails to start | 1. | Engine switch is in the off position | 1. | Move switch to start. |
| . | No fuel in tank | . | Fill tank. |
| 3. | Spark plug shorted or fouled | 3. | Replace spark plug. |
| 4. | Spark plug is broken (cracked | 4. | Replace spark plug. |
|
| porcelain or electrodes broken) |
|
|
| 5. | Ignition lead wire shorted, broken, | 5. | Replace lead wire or attach to spark |
|
| or disconnected from spark plug |
| plug. |
| 6. | Ignition inoperative | 6. | Contact authorized service center. |
|
|
|
|
|
Engine hard to start | 1. | Water in gasoline | 1. | Drain entire system and refill with |
|
|
|
| fresh fuel. |
| . Engine is under or over choked | 2. | Adjust choke as necessary. | |
| 3. | Weak spark at spark plug | 3. | Contact authorized service center. |
|
|
|
|
|
Engine lacks power | 1. | Dirty air filter | 1. | Clean or replace air filter. |
|
|
|
|
|
Detergent fails to mix with spray | 1. | Detergent injection hose is not | 1. | Insert injection hose into detergent |
|
| properly submerged |
| storage bucket. |
| . High pressure nozzle attached | 2. | Use low pressure nozzle (black) to | |
|
|
|
| apply detergent. |
|
|
|
|
|
Pump doesn’t produce pressure | 1. | Low pressure nozzle installed | 1. | Replace with high pressure nozzle. |
| . | Inadequate water supply | . | Provide adequate water flow. |
| 3. | Spray wand leaks | 3. | Replace wand. |
| 4. | Nozzle is clogged | 4. | Clean nozzle. |
| 5. | Pump is faulty | 5. | Contact authorized service center. |
|
|
|
| |
Machine doesn’t reach high | 1. Diameter of garden hose is too | 1. | Replace with 3/4 in. garden hose. | |
pressure |
| small |
|
|
| . Water supply is restricted | . Check garden hose for kinks, leaks, | ||
|
|
|
| and blockages. |
| 3. | Not enough inlet water | 3. | Open water source full force. |
| 4. | Wrong nozzle is attached | 4. | Attach the high pressure nozzle. |
|
|
|
|
|
19