ASSEMBLY
attaching the resting foot
See Figure 3.
nLift the machine slightly. Slide the resting foot into the bottom of the spray wand storage tube.
nPush the resting foot into the storage tube until the base of the machine rests in the grooves on top of the resting foot.
assembling the spray wand
See Figure 4.
To attach the assist handle assembly:
nRemove the wing screw from the assist handle assembly then slide the spray wand assembly onto the assist handle assembly bracket.
NOTE: The smooth side of the assist handle assembly can be facing down or up.
nPosition the assist handle between the ribs of the spray wand aligning the tab and the detent.
nSecure the assist handle in place by tightening the wing screw.
To attach the spray wand extension:
nPlace the threaded end of the wand extension in the connector on the end of the spray wand assembly. Push until it snaps into place.
nTurn the connector clockwise until it stops. This secures the wand extension in place.
nWhen not in use, place the assembled spray wand into the spray wand storage.
connecting high pressure hose to spray wand Assembly
See Figure 5.
nUncoil the high pressure hose.
nPull back and hold the
nInsert the inlet coupler on the spray wand handle into the collar.
nRelease the collar and push until it clicks.
nPull on the hose to be certain it is properly secured.
attaching INJECTION hose
See Figure 6.
Before detergent can be used with this machine, the injection hose must be attached.
nUncoil the clear injection hose.
nPush the open end of the injection hose securely over the barbed fitting.
nLift the chemical bucket and push the injection hose into the slot on the back of the bucket.
nReplace the bucket in the bucket holder.
resting 
foot
Fig. 3
DETENT
TAB
| sPRAY |
| WAND |
| CONNECTOR |
| ribs |
ASSIST | SPRAY |
HANDLE | |
ASSEMBLY | WAND |
| EXTENSION |
| Fig. 4 |
| inlet |
| coupler |
high |
|
PRESSURE |
|
HOSE |
|
| quick- |
| connect |
| COLLAR |
Fig. 5
10