Pecoware TBB-3000 owner manual Drive Belt Adjustment

Page 17

DRIVE BELT ADJUSTMENT

The drive belt should be checked periodically for the correct tension. There should be 1” of movement for 16 lbs. of tension applied to the center of the belt. Apply the tension to the center of the belt, on the side of the belt opposite the drive belt idler. To adjust the belt, follow the steps below and refer to the figures for reference:

1.Use a floor jack to raise the machine off the ground and blocks to support the chassis and deck.

2.Remove the engine deck rear guard and the lower deck pan.

3.Engage the blade control.

4.Use a tension gauge to check the tension on the drive belt. Apply tension to the center of the belt, on the side opposite the drive belt idler. The correct tension is 1” of movement for 16 lbs. of tension applied to the center of the belt.

5.If the belt needs adjustment, turn the drive belt adjustment bolt clockwise to increase the tension or counter-clockwise to decrease the tension.

6.Disengage the blade control.

7.Replace the engine deck rear guard and lower deck pan.

REMOVE ENGINE

DECK REAR GUARD

REMOVE

LOWER

DECK PAN

DRIVE BELT

IDLER

DRIVE BELT

ADJUSTMENT

BOLT

APPLY

TENSION

17

Image 17
Contents Model TBB-3000 Safety Alert Symbols Table of ContentsGeneral Safety Rules Safety Decals What is WARRANTED? Peco Limited Warranty for NEW ProductsFeatures and Controls Spindle Features and Controls Features and Controls Starting the Brush Blazer OperationSteering Left Forward MovementReverse Movement Right Zero Turn Manuever Left Zero Turn ManeuverSteering Right Engagement Blade ENGAGEMENT/DISENGAGEMENTDisengagement Tips on Brush CuttingReverse Speed Adjustment Pump AdjustmentIdler Bolt Pump Belt AdjustmentPIN Startdrive Belt Idler Adjustment ROD Drive Belt Idler Drive Belt Idler AdjustmentAdjustment Cross Tension Fully Disengaged Section Here ROD Clutch Control Crank Drive Belt CotterDrive Belt Adjustment Mower Deck Pulley Alignment Deck Belt AdjustmentReplacement Deck and Drive Belt REMOVAL/REPLACEMENTRemove Drive Belt Adjustment Bolt Remove Main Drive TAKE-UP RemovalRemove Drive Belt Remove Belt From Pulley LoosenCorrect Tension 1-1/2 of Movement Track ADJUSTMENT/REMOVAL/REPLACEMNTAdjustment Charging the Hydraulic System Charging the Hydraulic System See page 25 for Wire Location and Wire Connection Table Wiring DiagramWire Connections Wire LocationsBlade Replacement Blade Shaft AssemblyLoweror DEATH. Bearing Cutting DegreesLabel Replacement Part Numbers Battery Replacement Regular MaintenanceElectrical System Service AIR Cleaner ServiceHydraulic OIL Scheduled Replacement Parts ListHydraulic System Exploded View Parts List Track Assembly Exploded View and Parts List Deck Assembly Exploded View Parts List Tree Gate Assembly Exploded View Parts List Caster Assembly Page Counter Shaft Exploded View and Parts List Fuel Line Exploded View and Parts List Tower Exploded View Parts List Instrument Cluster Exploded View Parts List Deck and Drive Belt Exploded View Parts List FRS ROD Assembly Exploded View and Parts List Chassis Components Hydraulic Components Exploded View Parts List Battery and Muffler Guard Exploded View and Parts List Deck MNTG. Plate Assy Deck to Chassis Exploded View Parts ListsPage ARDEN, North Carolina