Pecoware TBB-3000 owner manual Charging the Hydraulic System

CHARGING THE HYDRAULIC SYSTEM

!DANGER

DO NOT EXCEED MORE THAN 10 POUNDS OF PRESSURE WHEN CHARGING THE HYDRAULIC SYSTEM. FAILURE TO DO SO MAY RESULT IN SYSTEM FAILURE AND/OR PERSONAL INJURY.

CONTACT YOUR BRUSH BLAZER DEALER FOR THE HYDRAULIC CHARGING KIT ORDERING INFORMATION:

?HYDRAULIC CHARGING KIT (PART#: TBB2-0068) INCLUDES:

(1)1/4” AIR REGULATOR WITH GAUGE (PART#: TBB2-0067)

(1)1/4” FEMALE COUPLER (PART#: TBB2-0066)

(1)1/4” MALE PLUG (PART#: TBB2-0063)

(1)HYDRAULIC OIL TANK CAP WITH FITTING (PART#: TBB2-0065) INCLUDES:

(1)HYDRAULIC OIL TANK CAP DRILLED FOR 1/4” NPT (PART#: TBB2-0064)

(1)1/4” MALE PLUG (PART#: TBB2-0063)

TOOLS REQUIRED:

(1) AIR COMPRESSOR

(1)AIR HOSE WITH 1/4” FEMALE COUPLER

(1)CONTAINER FOR COLLECTING FLUID

(1)HYDRAULIC CHARGING KIT

PROCEDURE:

1.Loosen, but do not remove the charge relief valve on both hydraulic pumps. Figure 1

2.Disconnect the return line. Attach a hose to the end of the return line and use a suitable container to collect any fluid leakage that may occur. Figure 2

LOOSEN THE

CHARGE

DISCONNECT RETURN

RELIEF VALVE

LINE AND ATTACH HOSE

TO CONTAINER

FIGURE 1 FIGURE 2

22