Poulan 96042007200, 419756 manual Transaxle Motion Control Lever Neutral Adjustment See Fig

Page 22

SERVICE AND ADJUSTMENTS

TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT (See Fig. 33)

The motion control lever has been preset at the factory and adjustment should not be necessary.

•Loosen adjustment bolt in front of the right rear wheel, and lightly tighten.

•Start engine and move motion control lever until tractor does not move forward or backward.

•Hold motion control lever in that position and turn engine off.

•While holding motion control lever in place, loosen the adjustment bolt.

•Move motion control lever to the neutral (lock gate) position.

•Tighten adjustment bolt securely.

NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

After above adjustment is made, if the tractor still creeps forward or backward while motion control lever is in neutral position, follow these steps:

•Loosen the adjustment bolt.

•Move the motion control lever 1/4 to 1/2 inch in the direction it is trying to creep.

•Tighten adjustment bolt securely.

•Start engine and test.

•If tractor still creeps, repeat above steps until satisfied.

MOTION CONTROL LEVER

NEUTRAL

 

LOCK GATE

ADJUSTMENT

BOLT

Fig. 33

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 34)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

22

RETAINING WASHERS

RING

AXLE

COVER

SQUARE KEY (REAR WHEEL ONLY)

Fig. 34

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

TO START ENGINE WITH A WEAK BATTERY (See Fig. 35)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Maintenance section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WEAK OR

FULLY CHARGED

DEAD BATTERY

BATTERY

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Fig. 35

Page 21 Page 23
Image 22
Page 21 Page 23
Contents XT195H42LT ModelGeneral Operation Safe Operation Practices for Ride-On MowersII. Slope Operation III. Children ServiceIV. Towing Table of Contents Unassembled Parts Steering WheelBefore Removing Tractor from Skid Tools Required for AssemblyTo Remove Tractor from Carton Unpack CartonInstall Seat See Figs Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Stopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control See FigReverse Operation System ROS See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerTowing Carts and Other Attachments Before Starting the EngineTo Operate on Hills Check Engine OIL LevelPurge Transmission Mowing TipsAutomatic Transmission Warm UP Schedule MaintenanceGeneral Recommendations Before Each USETractor BatteryBlade Removal See Fig Cleaning EngineTo Install Mower See Figs To Remove Mower See FigInstall belt on engine pulley M Mower Tighten Loosen Adjust NUT To Raise To LowerTo Level Mower Loosen JAM NUT a FirstTo Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbEngine OIL OtherFuel System CylindersTroubleshooting Points Problem Cause CorrectionEngine dies when Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeCanada contact Outdoor Products Customer Service DeptHOP Stevens Creek Road Terry Fox Way Augusta, GA 30907 USAAutorisé Dept Service Customer Products OutdoorCanada Au Garantie cette de exclus sont normal l’entretien etDegrés Suivant LES UNE Pliez EST CeciDépannage DE Guide Défectueux estRalenti Entreposage Réglages ET Révision Rossage Fig la Voir TionsraparéLES Pour Roues LES Enlever Pour AVANT/CAR Roues DES Convergence’EN Courroie LA Remplacer Pour Fig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl PourTondeuse DE Lame DE Mentnetraî Freins LES Vérifier Pour29 .Fig Tondeuse LA Niveau LE Ajuster Pour30 .Fig 28 .Fig24 .Fig 26 .Fig25 .Fig 23 .FigFig Voir Cour LA ET Tondeuse LA InstallerFigs Voir D’ENTRAÎNEMENT Roie Tondeuse LA Enlever PourEntretien MoteurLames DES Entretien Transmission LA DE RefroidissementFig la Voir Lame LA Enlever PneusLubrification DE Tableau O I T a D N a M M O C E RUtilisation Chaque Avant Tonte DE Conseils UtilisationTransmission LA Purger 15 .Fig’ESSENCE Réservoir LE Remplir Accessoires Autres ET Charrettes DES Remorquer PourMoteur LE Démarrer Pour Tracteur LE Transporter PourJauge DE Roues LES Régler Pour Fig la Voir ROS Arrière CHEMAR EN Fonctionnement DE Système Tondeuse LA Utiliser PourReculer Pour ET Avancer Pour GAZ DES Commande LA Utiliser PourFig la Voir Mentne -TIONSTA DE Frein LE Engager Pour Fig la Voir Arrêter Pour 6 .Fig’OPÉRA DE Présence DE Système DU Commutateur Propriété la de lendommagement Correctement Sont Courroies LES MontageToutes SI Vérifier Toutes SI Vérifier PA LA DE Tracteur LE Retirer Pour Fig la Voir Batterie LA Vérifier DU Tracteur LE Sortir PourLE Pour Exigés Outils LES Tionrecdi DE Volant LE FixerMontar SIN Piezas SiègeGarantie U1R DimensionSommaire CCA .MIN AMP/HR’utilisation pour Conseils Général EntretienTracteurs des sécurité toute ’ESSENCE DE Sûre ManipulationLES Dans Fonctionnement PentesTracteurs des sécurité toute en l’utilisation pour Conseils Avertissement

419756, 96042007200 specifications

The Poulan 96042007200,419756 is a versatile and powerful chainsaw designed for both professionals and homeowners. This robust tool is ideal for a variety of tasks including tree trimming, cutting firewood, and general landscaping. Its performance, combined with user-centric features, makes it a popular choice among outdoor enthusiasts.

One of the standout characteristics of the Poulan 96042007200 is its powerful engine. Equipped with a 42cc, 2-cycle engine, this chainsaw delivers impressive cutting power while maintaining a lightweight design, making it easy to maneuver. The engine's efficient design helps it to handle tough jobs without bogging down, ensuring that users can accomplish their tasks with ease.

In terms of technology, the chainsaw features an automatic oiler system. This innovation provides a steady supply of oil to the chain and bar, ensuring optimal lubrication during operation. This feature not only enhances cutting efficiency but also prolongs the life of the chainsaw by reducing wear and tear on the components.

Another important aspect of the Poulan 96042007200,419756 is its ergonomics. The chainsaw is designed with a comfortable grip and an adjustable handle, which allows users to maintain control even during prolonged use. This attention to user comfort translates to less fatigue and more productive working sessions.

Safety is also a key consideration in the design of this chainsaw. The Poulan 96042007200 incorporates a chain brake that helps to prevent accidents by stopping the chain immediately in the event of kickback. Furthermore, the chainsaw is equipped with protective covers to shield the user from debris and other hazards typically associated with cutting tasks.

The chainsaw features a 16-inch bar, which strikes a perfect balance between cutting capacity and maneuverability. This size is suitable for a wide range of cutting jobs, making it adaptable to various user needs. Coupled with a low-profile chain, it delivers smoother cuts and improved control during operation.

Overall, the Poulan 96042007200,419756 is a reliable chainsaw that combines power, technology, and user-friendly features. It is an excellent choice for anyone in need of a dependable cutting tool that can handle a multitude of outdoor tasks efficiently and safely.
Top Page Image Contents