Poulan 425858, 9604200602 manual To Remove Mower See Fig, To Install Mower, To Level Mower

Page 21

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress brake pedal fully and set parking brake.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 28)

•Place attachment clutch in “DISENGAGED” posi- tion.

•Lower attachment lift lever to its lowest position.

•Disengage belt tension rod (K) from lock bracket

(L).

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and release slowly.

•Remove mower belt from electric clutch pulley

•Disconnect front link (E) from mower - remove retainer spring and washer.

•Go to either side of mower and disconnect mower suspension arm (A) from chassis and rear lift link

(C)from rear mower bracket (D) - remove retainer springs and washers.

•Go to other side of mower and disconnect the suspension arm and rear lift link.

•From right side of mower, disconnect anti-sway bar (S) from right rear mower bracket (D) - remove retainer spring and washer and pull mower toward you until the bar falls from the hole in bracket.

•Turn tractor steering wheel to the left as far as it will go.

•Slide mower out from under right side of tractor.

TO INSTALL MOWER

Follow procedure described in “INSTALL MOWER AND DRIVE BELT” in the Assembly section of this manual.

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 29)

•With all tires properly inflated and if your lawn ap- pears unevenly cut, determine which side of mower is cutting lower.

CAUTION: After rear lift links are dis- connected, the attachment lift lever will be spring loaded. Have a tight grip on lift lever when changing position of the lever.

NOTE: As desired, you can raise the low side of mower or lower the high side.

•Go to side of mower you wish to adjust.

LB

M

K

F

A

E

H

S

C

D

FIG. 28

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents 425858 12-01-08 BAD ModelSafe Operation Practices for Ride-On Mowers General OperationII. Slope Operation General Service ServiceIII. Children IV. TowingTable of Contents Unpack Carton To Remove Tractor from CartonAdjust Seat See Fig Install Mower and Drive BeltRoll tractor forward off skid Attach Mower Side Suspension Arms a First Install ANTI-SWAY BAR SEH J Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Reverse Operation System ROS on Position Know Your TractorStopping HOW to USE Your TractorTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo USE Cruise Control -J See Fig To Operate MowerReverse Operation System ROS Service REMINDER/HOUR MeterTo Transport See Figs To Operate on HillsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigPurge Transmission Mowing TipsLubrication Chart General RecommendationsBefore Each USE Tractor BatteryBrake Operation Blade CareBelts EngineTransaxle Cooling Transaxle Pump FluidCleaning To Install Mower To Remove Mower See FigTo Level Mower To lower mower Turn nut right Turn nut left To raise mowerTo Replace Mower Blade Drive Belt To Check BrakeTo Replace Motion Drive Belt To Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs See Fig To Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbFuel System OtherEngine OIL CylindersProblem Cause Correction Troubleshooting PointsMower blades will not HOP Limited WarrantyService Notes Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Dentretien Notes Limitée Garantie Correction Cause Problème Dépannage DE GuideLa réduisez ou haute plus coupe de position en Mettez Entreposage Reglages ET Revision Carburateur LE Régler PourFig la Voir Batterie LA Replacer Roue LA DE PINCEMENT/CARROSSAGE AvantLA DE Lame LA DE D’ENTRAÎNEMENT FIG LA Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl PourCourroie Acer Rempl Pour Freins LES Vérifier PourAVANT/ARRIÈRE Ajustement Fig la Voir Tondeuse LA Installer PourTondeuse LA Niveau LE Ajuster Pour Tondeuse LA Enlever PourFig La Voir Coupe DE Plateau DU Lavage DE Raccord Entretien’ALLUMAGE Bougie AIR À FiltreSionmistrans LA DE Moteur Fluide LubrificationTransmission LA DE Refroidissement Trapézoïdales CourroiesFig la Voir Lame LA Enlever Lames DES EntretienEN Fonctionnement DE Système ET Généra Recommandations LES Lubrification DE TableauUtilisation Chaque Avant Utilisation Transmission LA Purger22 .FIG ’ESSENCE Réservoir LE Remplir Moteur LE Démarrer PourMoteur DU D’HUILE Niveau LE Vérifier Quetima’ENTRETIEN/HOROMÈTRE Indicateur Accessoires Autres ET Charrettes DES Remorquer Pour21 et 13 .Fig les Voir Pentes LES Dans Utiliser PourTondeuse LA Utiliser Pour Fig la Voir J- Vitess DE Régulateur LE Utiliser CommentJauge DE Roues LES Régler Pour Système DU CaractéristiquesFig la Voir Mentne -TIONSTA DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourReculer Pour ET Avancer Pour Létrangleur Utiliser Pour13 .FIG ’EMBRAYAGE NI DE EST Tondeuse LA SI Vérifier Montage10 .FIG 12 .FIG 11 .FIGLA DE Latéraux Suspension DE Bras LES Fixez ROULIS-ANTI Barre LA D’ABORD InstallezPAL LA DE Tracteur LE Retirer Pour PA LA DE Tracteur LE Retirer PourToncar DU Tracteur LE Sortir Pour Montées NON PiécesFig la Voir Batterie LA Vérifier Clés Pente-GuideGarantie ’ENTRETIEN Guide SommaireUtilisation Réglages ET Révision Produit DE SpécificationsTracteurs des sécurité toute Général EntretienEn l’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationTracteurs des sécurité toute en l’utilisation pour Conseils TESAUX Imprimé BAD 08-01-12Avertissement

425858, 9604200602 specifications

The Poulan 425858, 9604200602 model is a powerful and versatile tool designed for outdoor enthusiasts and professionals alike. This chainsaw is part of Poulan's commitment to delivering performance and reliability in lawn and garden equipment. Known for its user-friendly features and robust construction, the Poulan 425858 is an excellent choice for cutting firewood, tree trimming, and various landscaping tasks.

One of the standout features of the Poulan 425858 is its powerful engine. Equipped with a high-performance 42cc gas engine, this chainsaw is capable of handling tough cutting tasks with ease. The engine provides ample power while maintaining fuel efficiency, allowing users to work longer without frequent refueling. The chainsaw's automatic oiling system also ensures that the bar and chain remain lubricated during operation, extending the tool's lifespan and performance.

The design of the Poulan 425858 prioritizes user comfort and safety. Its ergonomic handle and lightweight construction make it easy to maneuver, reducing user fatigue during extended use. The chainsaw is also fitted with a low-vibration technology that minimizes vibration levels, enhancing comfort further while reducing the risk of fatigue and discomfort in the hands and arms.

Safety features are paramount in the design of the Poulan 425858. The chainsaw includes a chain brake that automatically stops the chain in case of kickback, providing peace of mind to the user. Additionally, the tool’s safety throttle lock prevents accidental starting, ensuring that the chainsaw only operates when the user is ready.

Adjustment and maintenance are made simple with this model. The Poulan 425858 features a tool-less chain tensioning system, allowing users to quickly and easily adjust the chain tension without the need for additional tools. This feature ensures optimal performance and safety, as a properly tensioned chain reduces the likelihood of accidents.

In summary, the Poulan 425858, 9604200602 model is a reliable and efficient chainsaw that combines power, safety, and ease of use. With its efficient engine, user-friendly design, and proactive safety features, it is well-suited for both casual users and professionals. Whether you're tackling tough jobs around the yard or maintaining trees on a larger property, the Poulan 425858 is a dependable tool that delivers on performance and convenience.
Top Page Image Contents