Poulan 9604200602, 425858 manual Other, Fuel System, Engine OIL, Cylinders

Page 26

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Main- tenance section of this manual).

•Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjust- ments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, break- age and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage dur- ing long periods of storage, battery cables should be disconnected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Maintenance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to an- other.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Model 425858 12-01-08 BADII. Slope Operation Safe Operation Practices for Ride-On MowersGeneral Operation III. Children ServiceGeneral Service IV. TowingTable of Contents To Remove Tractor from Carton Unpack CartonRoll tractor forward off skid Adjust Seat See FigInstall Mower and Drive Belt First Install ANTI-SWAY BAR S Attach Mower Side Suspension Arms aEH J Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingTo USE Cruise Control -J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerTo Transport See Figs Service REMINDER/HOUR MeterReverse Operation System ROS To Operate on HillsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Purge TransmissionBefore Each USE Lubrication ChartGeneral Recommendations Brake Operation BatteryTractor Blade CareTransaxle Cooling EngineBelts Transaxle Pump FluidCleaning To Level Mower To Install MowerTo Remove Mower See Fig Turn nut right Turn nut left To raise mower To lower mowerTo Replace Motion Drive Belt To Replace Mower Blade Drive BeltTo Check Brake To Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbEngine OIL OtherFuel System CylindersTroubleshooting Points Problem Cause CorrectionMower blades will not Limited Warranty HOPService Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Dentretien Notes Limitée Garantie Dépannage DE Guide Correction Cause ProblèmeLa réduisez ou haute plus coupe de position en Mettez Entreposage Fig la Voir Batterie LA Replacer Reglages ET RevisionCarburateur LE Régler Pour Avant Roue LA DE PINCEMENT/CARROSSAGECourroie Acer Rempl Pour FIG LA Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl PourLA DE Lame LA DE D’ENTRAÎNEMENT Freins LES Vérifier PourAVANT/ARRIÈRE Ajustement Tondeuse LA Niveau LE Ajuster Pour Tondeuse LA Installer PourFig la Voir Tondeuse LA Enlever Pour’ALLUMAGE Bougie EntretienFig La Voir Coupe DE Plateau DU Lavage DE Raccord AIR À FiltreTransmission LA DE Refroidissement LubrificationSionmistrans LA DE Moteur Fluide Trapézoïdales CourroiesEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverLames DES Entretien Utilisation Chaque Avant Généra Recommandations LESLubrification DE Tableau 22 .FIG UtilisationTransmission LA Purger Moteur DU D’HUILE Niveau LE Vérifier Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir Quetima21 et 13 .Fig les Voir Accessoires Autres ET Charrettes DES Remorquer Pour’ENTRETIEN/HOROMÈTRE Indicateur Pentes LES Dans Utiliser PourJauge DE Roues LES Régler Pour Fig la Voir J- Vitess DE Régulateur LE Utiliser CommentTondeuse LA Utiliser Pour Système DU CaractéristiquesReculer Pour ET Avancer Pour GAZ DES Commande LA Utiliser PourFig la Voir Mentne -TIONSTA DE Frein LE Engager Pour Létrangleur Utiliser Pour13 .FIG ’EMBRAYAGE Montage NI DE EST Tondeuse LA SI Vérifier12 .FIG 11 .FIG 10 .FIGROULIS-ANTI Barre LA D’ABORD Installez LA DE Latéraux Suspension DE Bras LES FixezPA LA DE Tracteur LE Retirer Pour PAL LA DE Tracteur LE Retirer PourFig la Voir Batterie LA Vérifier Montées NON PiécesToncar DU Tracteur LE Sortir Pour Clés Pente-GuideUtilisation SommaireGarantie ’ENTRETIEN Guide Réglages ET Révision Produit DE SpécificationsEn l’utilisation pour Conseils Général EntretienTracteurs des sécurité toute ’ESSENCE DE Sûre ManipulationTES Tracteurs des sécurité toute en l’utilisation pour ConseilsAvertissement AUX ImpriméBAD 08-01-12

425858, 9604200602 specifications

The Poulan 425858, 9604200602 model is a powerful and versatile tool designed for outdoor enthusiasts and professionals alike. This chainsaw is part of Poulan's commitment to delivering performance and reliability in lawn and garden equipment. Known for its user-friendly features and robust construction, the Poulan 425858 is an excellent choice for cutting firewood, tree trimming, and various landscaping tasks.

One of the standout features of the Poulan 425858 is its powerful engine. Equipped with a high-performance 42cc gas engine, this chainsaw is capable of handling tough cutting tasks with ease. The engine provides ample power while maintaining fuel efficiency, allowing users to work longer without frequent refueling. The chainsaw's automatic oiling system also ensures that the bar and chain remain lubricated during operation, extending the tool's lifespan and performance.

The design of the Poulan 425858 prioritizes user comfort and safety. Its ergonomic handle and lightweight construction make it easy to maneuver, reducing user fatigue during extended use. The chainsaw is also fitted with a low-vibration technology that minimizes vibration levels, enhancing comfort further while reducing the risk of fatigue and discomfort in the hands and arms.

Safety features are paramount in the design of the Poulan 425858. The chainsaw includes a chain brake that automatically stops the chain in case of kickback, providing peace of mind to the user. Additionally, the tool’s safety throttle lock prevents accidental starting, ensuring that the chainsaw only operates when the user is ready.

Adjustment and maintenance are made simple with this model. The Poulan 425858 features a tool-less chain tensioning system, allowing users to quickly and easily adjust the chain tension without the need for additional tools. This feature ensures optimal performance and safety, as a properly tensioned chain reduces the likelihood of accidents.

In summary, the Poulan 425858, 9604200602 model is a reliable and efficient chainsaw that combines power, safety, and ease of use. With its efficient engine, user-friendly design, and proactive safety features, it is well-suited for both casual users and professionals. Whether you're tackling tough jobs around the yard or maintaining trees on a larger property, the Poulan 425858 is a dependable tool that delivers on performance and convenience.
Top Page Image Contents