Poulan 9604200602, 425858 manual Adjust Seat See Fig, Install Mower and Drive Belt

Page 6

ASSEMBLY

ADJUST SEAT (See Fig. 2)

•Sit in seat.

•Lift up adjustment lever (A) and slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

•Release lever to lock seat in position.

ASSEMBLE FRONT WHEEL TO MOWER (See Fig. 3)

•Using shoulder bolt, washer and locknut from parts bag, assemble front wheel to mower as shown. Tighten securely.

A

FIG. 2

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Release parking brake by depressing brake pedal.

•Place freewheel control in disengaged position to disengage transmission (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Be sure all the above assembly steps have been completed.

•Check engine oil level and fill fuel tank with gaso- line.

•Place freewheel control in "transmission engaged" position (see "TO TRANSPORT" in Operation sec- tion of this manual).

•Sit on seat in operating position, depress brake pedal and set the parking brake.

•Raise attachment lift lever to its highest position.

•Remove key from bag and start the engine (see "TO START" in the Operation section of this manual). After engine has started, move throttle control to idle (slow) position.

•Release parking brake.

•Slowly depress forward drive pedal and drive trac- tor off skid.

•Apply brake to stop tractor and set parking brake.

•Turn ignition key to "STOP" position.

Continue with the instructions that follow.

6

 

FIG. 3

INSTALL MOWER AND DRIVE BELT

(See Figs. 4-12)

See MOWER AND DRIVE BELT ASSEMBLY Supplement Sheet for additional guidance on this assembly.

Be sure tractor is on level surface and engage park- ing brake.

•Lower attachment lift lever to lowest position.

CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position.

•Turn steering wheel to the left as far as it will go and position mower on right side of tractor with deflector shield to the right.

02965

FIG. 4

•Remove plastic tie securing belt, bring belt forward and check belt for proper routing in all mower pul- ley grooves.

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Model 425858 12-01-08 BADSafe Operation Practices for Ride-On Mowers General OperationII. Slope Operation III. Children ServiceGeneral Service IV. TowingTable of Contents To Remove Tractor from Carton Unpack CartonAdjust Seat See Fig Install Mower and Drive BeltRoll tractor forward off skid First Install ANTI-SWAY BAR S Attach Mower Side Suspension Arms aEH J Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingTo USE Cruise Control -J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerTo Transport See Figs Service REMINDER/HOUR MeterReverse Operation System ROS To Operate on HillsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Purge TransmissionLubrication Chart General RecommendationsBefore Each USE Brake Operation BatteryTractor Blade CareTransaxle Cooling EngineBelts Transaxle Pump FluidCleaning To Install Mower To Remove Mower See FigTo Level Mower Turn nut right Turn nut left To raise mower To lower mowerTo Replace Mower Blade Drive Belt To Check BrakeTo Replace Motion Drive Belt To Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs See Fig To Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbEngine OIL OtherFuel System CylindersTroubleshooting Points Problem Cause CorrectionMower blades will not Limited Warranty HOPService Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Dentretien Notes Limitée Garantie Dépannage DE Guide Correction Cause ProblèmeLa réduisez ou haute plus coupe de position en Mettez Entreposage Reglages ET Revision Carburateur LE Régler PourFig la Voir Batterie LA Replacer Avant Roue LA DE PINCEMENT/CARROSSAGECourroie Acer Rempl Pour FIG LA Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl PourLA DE Lame LA DE D’ENTRAÎNEMENT Freins LES Vérifier PourAVANT/ARRIÈRE Ajustement Tondeuse LA Niveau LE Ajuster Pour Tondeuse LA Installer PourFig la Voir Tondeuse LA Enlever Pour’ALLUMAGE Bougie EntretienFig La Voir Coupe DE Plateau DU Lavage DE Raccord AIR À FiltreTransmission LA DE Refroidissement LubrificationSionmistrans LA DE Moteur Fluide Trapézoïdales CourroiesFig la Voir Lame LA Enlever Lames DES EntretienEN Fonctionnement DE Système ET Généra Recommandations LES Lubrification DE TableauUtilisation Chaque Avant Utilisation Transmission LA Purger22 .FIG Moteur DU D’HUILE Niveau LE Vérifier Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir Quetima21 et 13 .Fig les Voir Accessoires Autres ET Charrettes DES Remorquer Pour’ENTRETIEN/HOROMÈTRE Indicateur Pentes LES Dans Utiliser PourJauge DE Roues LES Régler Pour Fig la Voir J- Vitess DE Régulateur LE Utiliser CommentTondeuse LA Utiliser Pour Système DU CaractéristiquesReculer Pour ET Avancer Pour GAZ DES Commande LA Utiliser PourFig la Voir Mentne -TIONSTA DE Frein LE Engager Pour Létrangleur Utiliser Pour13 .FIG ’EMBRAYAGE Montage NI DE EST Tondeuse LA SI Vérifier12 .FIG 11 .FIG 10 .FIGROULIS-ANTI Barre LA D’ABORD Installez LA DE Latéraux Suspension DE Bras LES FixezPA LA DE Tracteur LE Retirer Pour PAL LA DE Tracteur LE Retirer PourFig la Voir Batterie LA Vérifier Montées NON PiécesToncar DU Tracteur LE Sortir Pour Clés Pente-GuideUtilisation SommaireGarantie ’ENTRETIEN Guide Réglages ET Révision Produit DE SpécificationsEn l’utilisation pour Conseils Général EntretienTracteurs des sécurité toute ’ESSENCE DE Sûre ManipulationTES Tracteurs des sécurité toute en l’utilisation pour ConseilsAUX Imprimé BAD 08-01-12Avertissement

425858, 9604200602 specifications

The Poulan 425858, 9604200602 model is a powerful and versatile tool designed for outdoor enthusiasts and professionals alike. This chainsaw is part of Poulan's commitment to delivering performance and reliability in lawn and garden equipment. Known for its user-friendly features and robust construction, the Poulan 425858 is an excellent choice for cutting firewood, tree trimming, and various landscaping tasks.

One of the standout features of the Poulan 425858 is its powerful engine. Equipped with a high-performance 42cc gas engine, this chainsaw is capable of handling tough cutting tasks with ease. The engine provides ample power while maintaining fuel efficiency, allowing users to work longer without frequent refueling. The chainsaw's automatic oiling system also ensures that the bar and chain remain lubricated during operation, extending the tool's lifespan and performance.

The design of the Poulan 425858 prioritizes user comfort and safety. Its ergonomic handle and lightweight construction make it easy to maneuver, reducing user fatigue during extended use. The chainsaw is also fitted with a low-vibration technology that minimizes vibration levels, enhancing comfort further while reducing the risk of fatigue and discomfort in the hands and arms.

Safety features are paramount in the design of the Poulan 425858. The chainsaw includes a chain brake that automatically stops the chain in case of kickback, providing peace of mind to the user. Additionally, the tool’s safety throttle lock prevents accidental starting, ensuring that the chainsaw only operates when the user is ready.

Adjustment and maintenance are made simple with this model. The Poulan 425858 features a tool-less chain tensioning system, allowing users to quickly and easily adjust the chain tension without the need for additional tools. This feature ensures optimal performance and safety, as a properly tensioned chain reduces the likelihood of accidents.

In summary, the Poulan 425858, 9604200602 model is a reliable and efficient chainsaw that combines power, safety, and ease of use. With its efficient engine, user-friendly design, and proactive safety features, it is well-suited for both casual users and professionals. Whether you're tackling tough jobs around the yard or maintaining trees on a larger property, the Poulan 425858 is a dependable tool that delivers on performance and convenience.
Top Page Image Contents