Poulan 96042003505 manual HOW to USE Your Tractor, To SET Parking Brake See Fig, Stopping See Figs

Page 11

OPERATION

The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spec- tacles or standard safety glasses.

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE (See Fig. 6)

Your tractor is equipped with an operator presence sens- ing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

Depress clutch/brake pedal (B) all the way down and hold.

Pull parking brake lever (C) up and hold, release pres- sure from clutch/brake pedal (B), then release parking brake lever. Pedal should remain in brake position. Make sure parking brake will hold tractor secure.

B

C

FIG. 6

STOPPING (See Figs. 7 and 8)

MOWER BLADES -

To stop mower blades, move attachment clutch clutch lever to disengaged position ().

E

J

(

 

) Attachment

(

 

) Disengaged

 

 

 

 

Clutch

 

 

Position

 

 

Engage Position

 

 

 

FIG. 7

11

GROUND DRIVE -

To stop ground drive, depress clutch/brake pedal all the way down.

Move gear shift lever (J) to neutral position.

ENGINE -

Move throttle control (D) between half and full speed (fast) position.

NOTE: Failure to move throttle control between half and full speed (fast) position, before stopping, may cause en- gine to “backfire”.

Turn ignition key (F) to “STOP” position and remove key. Always remove key when leaving tractor to prevent unauthorized use.

Never use choke to stop engine.

IMPORTANT: Leaving the ignition switch in any position other than "STOP" will cause the battery to discharge and go dead.

NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause “browning” of grass. To eliminate this possibility, al- ways stop engine when stopping tractor on grass areas.

CAUTION: Always stop tractor com- pletely, as described above, and set parking brake before leaving the operator's position.

D

F

FIG. 8

TO USE THROTTLE CONTROL (D) (See Fig. 8)

Always operate engine at full speed (fast).

Operating engine at less than full speed (fast) reduces the engine's operating efficiency.

Full speed (fast) offers the best mower performance.

TO MOVE FORWARD AND BACKWARD (See Fig. 9)

The direction and speed of movement is controlled by the gearshift lever (J).

Image 11
Contents Model PB19546LTII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceIII. Children Table of Contents Key Slope Sheet Unassembled PartsBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Battery See Fig Install Seat See FigsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigsReverse Operation System ROS See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig Before Starting the Engine To Start Engine See Fig Mowing TipsLubrication Chart MaintenanceCheck Operator Presence System BatteryTractor Blade Removal See FigEngine IN-LINE Fuel Filter See Fig CleaningTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Figs Install belt on engine pulley M To Level Mower To Replace Motion Belt Drive See Fig Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Attach Jumper Cables To Adjust Steering Wheel AlignmentReplacing Battery See Figs Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Service Notes Fold Alon THI Dotted Line REE Lope Only Ride UP and Down Hill Not Across Hill Degrees MAXPage Page Degrés ’ENTRETIEN Remarques Défectueux est Dépannage DE GuideRalenti Entreposage Carburateur LE Régler Pour Starter DU Commande LA Régler PourGAZ DES Commande Réglages ET RévisionChargée Mentretièen Batterie Déchargée OU Faible Batterie Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourCarrossage AVANT/ Roues DES Convergence Tionrecdi LA DE L’ALIGNEMENT Régler PourTondeuse DE Lame DE Mentnetraî 33 .FigFIG LA Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour FIG LA Voir28 .FIG Tondeuse LA Niveau LE Ajuster Pour30 .FIG 29 .FIG23 .FIG 26 .FIG25 .FIG 24 .FIGFig Voir Cour LA ET Tondeuse LA InstallerReglages ET Revision Figs Voir D’ENTRAÎNEMENT RoieNettoyage Ligne EN Installé D’ESSENCE FiltreEntretien Fig la VoirMoteur Frein DU Fonctionnement Fig la Voir Lame LA EnleverLames DES Entretien PneusUtilisation Chaque Avant O I T a D N a M M O C E RLubrification DE Tableau 14 .FIG UtilisationTonte DE Conseils Moteur LE Démarrer PourET Charrettes DES Remorquer Pour Accessoires Autres’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE Vérifier10 .FIG Jauge DE Roues LES Régler Pour12 .FIG 11 .FIGTionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourEt 7 .Figs la Voir Arrêter Pour Fig la Voir MentneDattachement Propriété la de lendommagement Toutes SI Vérifier Toutes SI Vérifier MontageCorrectement Sont Courroies LES Et 2 .Figs les Voir Siège LE Ajustez Fig la Voir Batterie LA VérifierCarton LE Deballer DU Tracteur LE Sortir PourPour Exigés Outils LES Tionrecdi DE Volant LE FixerMontar SIN Piezas 24-19 Réglages ET Révision Sommaire27-26 Dépannage DE Guide ’ESSENCE DE Sûre Manipulation Général EntretienTracteurs des sécurité toute ’utilisation pour ConseilsTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement AUX Imprimé

96042003505 specifications

The Poulan 96042003505 is a high-performance chainsaw designed to meet the dynamic needs of both casual users and professional arborists. This robust tool is known for its reliability, efficiency, and ease of use, making it a popular choice among various outdoor maintenance enthusiasts.

One of the standout features of the Poulan 96042003505 is its powerful 42cc engine. This Two-Stroke engine delivers impressive cutting performance, allowing users to easily tackle a range of tasks from pruning trees to cutting firewood. The design emphasizes fuel efficiency and reduced emissions, aligning with modern environmental standards without compromising power.

Another key characteristic of the Poulan 96042003505 is its lightweight construction. Weighing in at approximately 12 pounds, it provides excellent maneuverability without sacrificing durability. The lightweight design means that users can operate the chainsaw for extended periods with reduced fatigue, making it ideal for large projects.

This chainsaw is equipped with a 16-inch bar, providing an optimal balance between cutting ability and control. The bar length allows users to cut through medium-sized trees and thick branches with ease, making it versatile for both residential and professional use.

Technologically, the Poulan 96042003505 features an automatic oiler system, ensuring a steady supply of lubrication to the chain. This system promotes longer chainsaw life and enhances cutting efficiency, offering users peace of mind that their tool is well-maintained during operation.

The chainsaw also boasts a tool-less chain tensioning system, allowing for quick and easy adjustments to the chain tension. This user-friendly feature saves time during maintenance and ensures optimal performance at all times.

Safety is a top priority in the design of the Poulan 96042003505. The chainsaw is equipped with a chain brake that quickly stops the chain in case of kickback, reducing the risk of injury. Additionally, the ergonomic handle design provides a comfortable grip, allowing users to maintain control while minimizing strain.

In summary, the Poulan 96042003505 is a well-rounded chainsaw that combines power, efficiency, and user-centric features. Its cutting-edge technologies and thoughtful design elements make it a dependable tool for both casual users and seasoned professionals alike.