Poulan 96042003505 manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 24

SERVICE AND ADJUSTMENTS

•Lift seat pan to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) ter- minal with remaining hex bolt and keps nut. Tighten securely.

SEAT PAN

 

FIG. 36

 

 

TERMINAL

KEPS NUT

COVER

 

HEX

BOLT

POSITIVE (RED) CABLE

NEGATIVE (BLACK) CABLE

 

 

 

FIG. 37

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 38)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT WIRE

CONNECTOR

03075

FIG. 38

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engine manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents PB19546LT ModelSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Unassembled Parts Key Slope SheetAssembly Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidInstall Seat See Figs Check Battery See FigCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To SET Parking Brake See FigStopping See Figs To USE Throttle Control D See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigReverse Operation System ROS See Fig Before Starting the Engine Mowing Tips To Start Engine See FigMaintenance Lubrication ChartBattery TractorBlade Removal See Fig Check Operator Presence SystemEngine Cleaning IN-LINE Fuel Filter See FigService and Adjustments To Install Mower See FigsTo Remove Mower See Fig Install belt on engine pulley M To Level Mower Transaxle Gear Shift Lever NEUTRAL- Adjustment See Fig To Replace Mower Blade Drive Belt See FigTo Check Brake To Replace Motion Belt Drive See FigTo Adjust Steering Wheel Alignment Replacing Battery See FigsFront Wheel TOE-IN/CAMBER To Attach Jumper CablesTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Alon THI Dotted Line REE LopePage Page Degrés ’ENTRETIEN Remarques Dépannage DE Guide Défectueux estRalenti Entreposage Starter DU Commande LA Régler Pour GAZ DES CommandeRéglages ET Révision Carburateur LE Régler PourFig la Voir Tionsraparé LES Pour Roues LES Enlever Pour Carrossage AVANT/ Roues DES ConvergenceTionrecdi LA DE L’ALIGNEMENT Régler Pour Chargée Mentretièen Batterie Déchargée OU Faible Batterie33 .Fig FIG LA Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl PourFIG LA Voir Tondeuse DE Lame DE MentnetraîTondeuse LA Niveau LE Ajuster Pour 30 .FIG29 .FIG 28 .FIG26 .FIG 25 .FIG24 .FIG 23 .FIGCour LA ET Tondeuse LA Installer Reglages ET RevisionFigs Voir D’ENTRAÎNEMENT Roie Fig VoirLigne EN Installé D’ESSENCE Filtre EntretienFig la Voir NettoyageMoteur Fig la Voir Lame LA Enlever Lames DES EntretienPneus Frein DU FonctionnementO I T a D N a M M O C E R Lubrification DE TableauUtilisation Chaque Avant Utilisation Tonte DE ConseilsMoteur LE Démarrer Pour 14 .FIGAccessoires Autres ’ESSENCE Réservoir LE RemplirMoteur DU D’HUILE Niveau LE Vérifier ET Charrettes DES Remorquer PourJauge DE Roues LES Régler Pour 12 .FIG11 .FIG 10 .FIGGAZ DES Commande LA Utiliser Pour Et 7 .Figs la Voir Arrêter PourFig la Voir Mentne Tionsta DE Frein LE Engager PourDattachement Propriété la de lendommagement Montage Correctement Sont Courroies LESToutes SI Vérifier Toutes SI Vérifier Fig la Voir Batterie LA Vérifier Et 2 .Figs les Voir Siège LE AjustezDU Tracteur LE Sortir Pour Pour Exigés Outils LESTionrecdi DE Volant LE Fixer Carton LE DeballerMontar SIN Piezas Sommaire 27-26 Dépannage DE Guide24-19 Réglages ET Révision Général Entretien Tracteurs des sécurité toute’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationPentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils AUX Imprimé

96042003505 specifications

The Poulan 96042003505 is a high-performance chainsaw designed to meet the dynamic needs of both casual users and professional arborists. This robust tool is known for its reliability, efficiency, and ease of use, making it a popular choice among various outdoor maintenance enthusiasts.

One of the standout features of the Poulan 96042003505 is its powerful 42cc engine. This Two-Stroke engine delivers impressive cutting performance, allowing users to easily tackle a range of tasks from pruning trees to cutting firewood. The design emphasizes fuel efficiency and reduced emissions, aligning with modern environmental standards without compromising power.

Another key characteristic of the Poulan 96042003505 is its lightweight construction. Weighing in at approximately 12 pounds, it provides excellent maneuverability without sacrificing durability. The lightweight design means that users can operate the chainsaw for extended periods with reduced fatigue, making it ideal for large projects.

This chainsaw is equipped with a 16-inch bar, providing an optimal balance between cutting ability and control. The bar length allows users to cut through medium-sized trees and thick branches with ease, making it versatile for both residential and professional use.

Technologically, the Poulan 96042003505 features an automatic oiler system, ensuring a steady supply of lubrication to the chain. This system promotes longer chainsaw life and enhances cutting efficiency, offering users peace of mind that their tool is well-maintained during operation.

The chainsaw also boasts a tool-less chain tensioning system, allowing for quick and easy adjustments to the chain tension. This user-friendly feature saves time during maintenance and ensures optimal performance at all times.

Safety is a top priority in the design of the Poulan 96042003505. The chainsaw is equipped with a chain brake that quickly stops the chain in case of kickback, reducing the risk of injury. Additionally, the ergonomic handle design provides a comfortable grip, allowing users to maintain control while minimizing strain.

In summary, the Poulan 96042003505 is a well-rounded chainsaw that combines power, efficiency, and user-centric features. Its cutting-edge technologies and thoughtful design elements make it a dependable tool for both casual users and seasoned professionals alike.
Top Page Image Contents