Poulan 96042003505 manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 25

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Maintenance section of this manual.

Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

Remove spark plug(s).

Pour one ounce of oil through spark plug hole(s) into cylinder(s).

Turn ignition key to “START” position for a few seconds to distribute oil.

Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

25

Image 25
Contents Model PB19546LTSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Key Slope Sheet Unassembled PartsTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Install Seat See FigsCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping See Figs To USE Throttle Control D See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigReverse Operation System ROS See Fig Before Starting the Engine To Start Engine See Fig Mowing TipsLubrication Chart MaintenanceTractor BatteryBlade Removal See Fig Check Operator Presence SystemEngine IN-LINE Fuel Filter See Fig CleaningTo Install Mower See Figs Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M To Level Mower To Replace Mower Blade Drive Belt See Fig Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Check Brake To Replace Motion Belt Drive See FigReplacing Battery See Figs To Adjust Steering Wheel AlignmentFront Wheel TOE-IN/CAMBER To Attach Jumper CablesTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Service Notes Fold Alon THI Dotted Line REE Lope Only Ride UP and Down Hill Not Across Hill Degrees MAXPage Page Degrés ’ENTRETIEN Remarques Défectueux est Dépannage DE GuideRalenti Entreposage GAZ DES Commande Starter DU Commande LA Régler PourRéglages ET Révision Carburateur LE Régler PourCarrossage AVANT/ Roues DES Convergence Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourTionrecdi LA DE L’ALIGNEMENT Régler Pour Chargée Mentretièen Batterie Déchargée OU Faible BatterieFIG LA Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour 33 .FigFIG LA Voir Tondeuse DE Lame DE Mentnetraî30 .FIG Tondeuse LA Niveau LE Ajuster Pour29 .FIG 28 .FIG25 .FIG 26 .FIG24 .FIG 23 .FIGReglages ET Revision Cour LA ET Tondeuse LA InstallerFigs Voir D’ENTRAÎNEMENT Roie Fig VoirEntretien Ligne EN Installé D’ESSENCE FiltreFig la Voir NettoyageMoteur Lames DES Entretien Fig la Voir Lame LA EnleverPneus Frein DU FonctionnementLubrification DE Tableau O I T a D N a M M O C E RUtilisation Chaque Avant Tonte DE Conseils UtilisationMoteur LE Démarrer Pour 14 .FIG’ESSENCE Réservoir LE Remplir Accessoires AutresMoteur DU D’HUILE Niveau LE Vérifier ET Charrettes DES Remorquer Pour12 .FIG Jauge DE Roues LES Régler Pour11 .FIG 10 .FIGEt 7 .Figs la Voir Arrêter Pour GAZ DES Commande LA Utiliser PourFig la Voir Mentne Tionsta DE Frein LE Engager PourDattachement Propriété la de lendommagement Correctement Sont Courroies LES MontageToutes SI Vérifier Toutes SI Vérifier Et 2 .Figs les Voir Siège LE Ajustez Fig la Voir Batterie LA VérifierPour Exigés Outils LES DU Tracteur LE Sortir PourTionrecdi DE Volant LE Fixer Carton LE DeballerMontar SIN Piezas 27-26 Dépannage DE Guide Sommaire24-19 Réglages ET Révision Tracteurs des sécurité toute Général Entretien’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationLES Dans Fonctionnement PentesTracteurs des sécurité toute en l’utilisation pour Conseils AUX Imprimé

96042003505 specifications

The Poulan 96042003505 is a high-performance chainsaw designed to meet the dynamic needs of both casual users and professional arborists. This robust tool is known for its reliability, efficiency, and ease of use, making it a popular choice among various outdoor maintenance enthusiasts.

One of the standout features of the Poulan 96042003505 is its powerful 42cc engine. This Two-Stroke engine delivers impressive cutting performance, allowing users to easily tackle a range of tasks from pruning trees to cutting firewood. The design emphasizes fuel efficiency and reduced emissions, aligning with modern environmental standards without compromising power.

Another key characteristic of the Poulan 96042003505 is its lightweight construction. Weighing in at approximately 12 pounds, it provides excellent maneuverability without sacrificing durability. The lightweight design means that users can operate the chainsaw for extended periods with reduced fatigue, making it ideal for large projects.

This chainsaw is equipped with a 16-inch bar, providing an optimal balance between cutting ability and control. The bar length allows users to cut through medium-sized trees and thick branches with ease, making it versatile for both residential and professional use.

Technologically, the Poulan 96042003505 features an automatic oiler system, ensuring a steady supply of lubrication to the chain. This system promotes longer chainsaw life and enhances cutting efficiency, offering users peace of mind that their tool is well-maintained during operation.

The chainsaw also boasts a tool-less chain tensioning system, allowing for quick and easy adjustments to the chain tension. This user-friendly feature saves time during maintenance and ensures optimal performance at all times.

Safety is a top priority in the design of the Poulan 96042003505. The chainsaw is equipped with a chain brake that quickly stops the chain in case of kickback, reducing the risk of injury. Additionally, the ergonomic handle design provides a comfortable grip, allowing users to maintain control while minimizing strain.

In summary, the Poulan 96042003505 is a well-rounded chainsaw that combines power, efficiency, and user-centric features. Its cutting-edge technologies and thoughtful design elements make it a dependable tool for both casual users and seasoned professionals alike.