Poulan 188781 owner manual INSTALL SEAT See Fig, Assembly, How To Set Up Your Tractor

Page 7
INSTALL SEAT (See Fig. 3)

ASSEMBLY

LABEL

FIG. 2

HOW TO SET UP YOUR TRACTOR

INSTALL SEAT (See Fig. 3)

Adjust seat before tightening adjustment knob.

Remove adjustment knob and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor.

Pivot seat upward and remove from the cardboard pack- ing. Remove the cardboard packing and discard.

Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan.

Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor.

Pivot seat and pan forward and assemble adjustment knob and flat washer loosely. Do not tighten.

Lower seat into operating position and sit on seat.

Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

Get off seat without moving its adjusted position.

Raise seat and tighten adjustment knob securely.

SEAT

SEAT PAN

SHOULDER

BOLT

FLAT WASHER

ADJUSTMENT

KNOB

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

Press lift lever plunger and raise attachment lift lever to its highest position.

Release parking brake by depressing clutch/brake pedal.

Place freewheel control in "transmission disengaged position" (See “TO TRANSPORT” in the Operation section of this manual).

Roll tractor forward off skid.

Remove banding holding the deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

Manual backgroundWARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

Be sure all the above assembly steps have been com- pleted.

Check engine oil level and fill fuel tank with gasoline.

Place freewheel control in "transmission engaged" position (see "TO TRANSPORT" in Operation section of this manual).

Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

Place motion control lever in neutral (N) position.

Press lift lever plunger and raise attachment lift lever to its highest position.

Start the engine.After engine has started, move throttle control to idle position.

Release parking brake.

Slowly move the motion control lever forward and slowly drive tractor off skid.

Apply brake to stop tractor, set parking brake and place motion control lever in neutral position.

Turn ignition key to "STOP" position.

Continue with the instructions that follow.

FIG. 3

7

 

Image 7
Contents LAWN TRACTOR MODELPD22H42STA IMPORTANT MANUALI. GENERAL OPERATION SAFETY RULESIV. SERVICE SAFE OPERATION PRACTICES FOR RIDE-ON MOWERSWARNING In order to prevent ac- cidental starting when setting up, transporting, adjusting or making re- pairs, always disconnect spark plug wire and place wire where it cannot contact spark plug PRODUCT SPECIFICATIONS TABLE OF CONTENTSCUSTOMER RESPONSIBILITIES Steering UNASSEMBLED PARTSSteering Wheel SeatCHECK BATTERY See Fig ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY HOW TO SET UP YOUR TRACTORINSTALL SEAT See Fig CHECK DECK LEVELNESS INSTALL MULCHER PLATE See FigsTO CONVERT TO BAGGING OR DISCHARGING CHECK TIRE PRESSUREOPERATION HEIGHT ADJUSTMENT KNOB - Used to adjust the mower cutting height KNOW YOUR TRACTORSTOPPING See Fig HOW TO USE YOUR TRACTORTO ADJUST MOWER CUTTING HEIGHT See Fig TO SET PARKING BRAKE See FigTO TRANSPORT See Figs. 5 and TO ADJUST GAUGE WHEELS See FigTO OPERATE MOWER See Fig TO OPERATE ON HILLSADD GASOLINE BEFORE STARTING THE ENGINETOWING CARTS AND OTHER ATTACH- MENTS CHECK ENGINE OIL LEVELPURGE TRANSMISSION MOWING TIPSMAX 1/3 MULCHING MOWING TIPSBEFORE EACH USE MAINTENANCELUBRICATION CHART GENERAL RECOMMENDATIONSTIRES BATTERYTRACTOR BRAKE OPERATIONTRANSAXLE PUMP FLUID ENGINEV-BELTS TRANSAXLE COOLINGAIR FILTER See Fig CLEANINGCLEAN AIR SCREEN CLEAN AIR INTAKE/COOLING AREASTO INSTALL MOWER See Fig SERVICE AND ADJUSTMENTSTO REMOVE MOWER See Fig BOTH FRONT LINKS MUST BE EQUAL IN LENGTH TO LEVEL MOWER HOUSINGWITH PARKING BRAKE “ENGAGED” TO CHECK AND ADJUST BRAKE See FigTO REPLACE MOWER BLADE DRIVE BELT See Fig TO REPLACE MOTION DRIVE BELT See FigFRONT WHEEL TOE-IN/CAMBER TRANSMISSION REMOVAL/REPLACEMENTTRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT See Fig TO ADJUST STEERING WHEEL ALIGN- MENTINTERLOCKS AND RELAYS TO START ENGINE WITH A WEAK BATTERY See FigREPLACING BATTERY See Fig TO REPLACE HEADLIGHT BULBTO ADJUST CARBURETOR TO REMOVE HOOD AND GRILL ASSEMBLY See FigTO ADJUST THROTTLE CONTROL CABLE See Fig TO ADJUST CHOKE CONTROL See FigENGINE OIL STORAGEOTHER FUEL SYSTEMHard to start TROUBLESHOOTING POINTSLoss of power Will not startengaged Battery will not chargeEngine continues to run with attachment clutchTRACTOR - - MODEL NUMBER PD22H42STA SCHEMATIC2441 ELECTRICAL144927 chassiselite svpro7 CHASSIS259 CHASSIS drive-fender.stlt29 DRIVEDRIVE steeringpl.lt47 STEERING ASSEMBLYTRACTOR - - MODEL NUMBER PD22H42STA SEAT ASSEMBLY WHEELS AND TIRES DECALS25,8 4,10 112 ENGINEOPTIONAL EQUIPMENT Spark Arrester engine-bs intek-twin39ENGINE 42deckman-t-path4 MOWER DECKMower Deck Assembly lift-rh.1pc.stlt10 MOWER LIFTMOWER LIFT LIMITED WARRANTY ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAX SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATIONFOR SERVICE OR REPLACEMENT PARTS PARTS AND SERVICE