Poulan PR185H42STD owner manual Recheck side-to-side adjustment

Page 21

SERVICE AND ADJUSTMENTS

SIDE-TO-SIDE ADJUSTMENT (See Figs. 19 and 20)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Three full turns of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE OF

BOTTOM EDGE OF

MOWER TO GROUND

MOWER TO GROUND

“A”

GROUND LINE

“A”

FIG. 19

SUSPENSION ARM

LIFT LINK ADJUSTMENT NUT

FIG. 20

FRONT-TO-BACK ADJUSTMENT (See Figs. 21 and 22)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO- SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position.

Check adjustment on right side of tractor. Measure distance “D” directly in front and behind the mandrel at bottom edge of mower housing as shown.

•Before making any necessary adjustments, check that both front links are equal in length. Both links should be approximately 10-3/8".

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nuts “F” against trunnion on both front links.

•To raise front of mower, loosen nut “F” from trunnion on both front links. Tighten nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nut “F” against trunnion on both front links.

•Recheck side-to-side adjustment.

MANDREL

"D""D"

FIG. 21

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

NUT "F"

NUT "E"

 

TRUNNION

 

 

FRONT LINKS

FIG. 22

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents PR185H42STD Safe Operation Practices for Ride-On Mowers Safety RulesBecome ALERT!!! Your Safety is IN- Volved Table of Contents Unassembled Parts Steering Wheel SeatSlope Sheet Tools Required for Assembly AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat See Fig Check Tire Pressure To SET UP Your Mower for MulchingCheck Deck Levelness To Convert to Bagging or DischargingOperation Motion Control Lever Selects the speed Know Your TractorHOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigTo Operate on Hills To Transport See FigsTowing Carts and Other ATTACH- Ments Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsMulching Mowing Tips Customer Responsibilities General RecommendationsBefore Each USE Brake Operation TractorTires Operator Presence SystemEngine Clean AIR INTAKE/COOLING Areas Clean AIR ScreenCleaning Engine OIL FilterTo Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigRecheck side-to-side adjustment Belt Installation To Adjust Brake See FigTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTransaxle Motion Control Lever Neutral Adjustment See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERReplacing Battery See Figs To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Attach Jumper CablesTo Adjust Carburetor Interlocks and RelaysTo Replace Fuse Other StorageFuel System Engine OILTroubleshooting Points OFF Tractor - Model Number PR185H42STD Schematic2122 Electrical175566 175158175141 121433XChassis 176554 174619174930 159 169473X428 CupholderDrive 175578 175765175556 175410Steering Assembly 177876 175121175146 175118174894 Seat AssemblyWheels and Tires DecalsSpark Arrester Engine Optional EquipmentEngine 143 159 144 150 145 148 Mower Deck146 142 147 147 142174284 17449371081010 173443Mower Lift 159460 Wire Asm Inner/Sprg W/plunger LT Limited Warranty Sighting Guide Suggested Guide for Sighting Slopes for Safe OperationParts and Service

PR185H42STD specifications

The Poulan PR185H42STD is a robust and efficient lawn mower that is designed to meet the needs of residential users looking for a reliable machine for lawn maintenance. This model combines power, versatility, and ease of use, making it an excellent choice for homeowners with medium to large-sized yards.

One of the standout features of the PR185H42STD is its 18.5 HP engine, which provides ample power to tackle a variety of mowing tasks. This Briggs & Stratton engine is known for its durability and performance, ensuring that the mower can handle thick grass and uneven terrain with ease. The engine's overhead valve design contributes to improved fuel efficiency and lower emissions, making it an environmentally friendly option.

The mower is equipped with a 42-inch cutting deck, which allows for wide swath mowing, reducing the time it takes to complete lawn care tasks. The cutting deck is designed with multiple height adjustments, enabling users to customize their cut between 1.5 to 4 inches. This versatility helps achieve the desired lawn height, catering to the varying needs of different grass types and seasonal conditions.

Another notable feature of the Poulan PR185H42STD is its electric start system, which eliminates the hassle often associated with manual pull starts. With the simple turn of a key, the mower roars to life, making it user-friendly and convenient, especially for those who may have difficulty with traditional starting mechanisms.

The PR185H42STD incorporates a hydrostatic transmission that offers smooth and continuous speed adjustment without shifting gears. This technology provides exceptional control over the mower’s speed, allowing users to navigate easily through tight corners and around garden beds. The mower’s tight turning radius further enhances maneuverability, making it suitable for intricate landscaping.

Furthermore, the mower features a comfortable high-back seat and ergonomic steering wheel design, promoting an enjoyable mowing experience. It also comes equipped with a cup holder and storage compartment for added convenience during operation.

With dependable construction and thoughtful design, the Poulan PR185H42STD promises a powerful, user-friendly lawn care solution that stands up to the demands of any residential lawn. Whether you’re maintaining a pristine yard or managing overgrown areas, this mower is a worthy companion for all your lawn maintenance needs.
Top Page Image Contents