Univex DSR470 manual Programming the Remote Control

3

Programming the Remote Control

The remote control is set at the factory to control all of the receiver functions, but to use it to operate your TV, you must "program" it for the brand you own. Follow these instructions to program the remote to control your TV.

1.Turn on the TV for programming.

2.Use the table that appears later in this section to find the brand of TV.

3.After the manufacturer’s brand name is a three-digit code number (or several three-digit codes).

4.Press and hold the TV key on the remote control for at least three seconds or until the light on your remote flashes.

5.If the remote control "accepts" the code, you will see several rapid flashes of the light. If it does not flash, repeat steps 3 and 4. After the remote control accepts the code, press the POWER key on the remote control to make sure the remote control is able to turn your component off. This means it is functioning properly.

6.If your component does not respond to the remote control POWER key, even though it has "accepted" the manufacturer’s code, repeat steps 3 and 4 using the second three-digit code from the table. If this does not work, try the third code, etc., until the remote control accepts the code and your component responds to the remote control POWER key.

24