Oreck WS-7013U instruction manual Maintenance And Care Instructions, Do not submerge in water

Page 13

responsive to ambient air currents because of the shielding effect of the display case. In addition, the case can act as a heat sink to absorb and store heat from external sources (i.e. handling of the case or radiant heat). In addition, the much greater range of the outdoor temperature sensor requires a different calibration curve than the indoor range. Error is usually greater at the extreme ends of a range, making it harder to compare different ranges with different curves. Under non-laboratory conditions, it is difficult to compensate for the above factors and obtain an accurate comparison.

MAINTENANCE AND CARE INSTRUCTIONS

●Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units.

●Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may scratch the displays and casings.

●Do not submerge in water.

●Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer.

●Opening the casings voids the warranty. Do not try to repair the unit.

12

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Register your product on the web at WS-7013U Wireless 433 MHz Temperature Station Instruction ManualDetailed Setup Guide TABLE OF CONTENTSFeatures TopicADDITIONAL EQUIPMENT INVENTORY OF CONTENTS5. Instruction Manual and Warranty Card 6. 2 AAA 1.5V batteries 1. The indoor temperature station Figure2. Batteries should be out of both units for 10 minutes QUICK SETUP4. DO NOT PRESS ANY BUTTONS FOR 10 MINUTES The remote temperature sensor has a range of80 feet in a straight line I. BATTERY INSTALLATION A. REMOTE TEMPERATURE SENSOR Press and release the SET button once more to complete the setupDETAILED SETUP GUIDE B. INDOOR TEMPERATURE STATION II. TIME A. SETTING THE TIME 4. Press and release the MIN/MAX button to set the hour B. RESETTING THE MINIMUM AND MAXIMUM TEMPERATURES IV. FEATURES A. MINIMUM AND MAXIMUM TEMPERATURESV. MOUNTING A. REMOTE TEMPERATURE SENSOR TROUBLESHOOTINGB. THE TEMPERATURE STATION Solution Opening the casings voids the warranty. Do not try to repair the unit MAINTENANCE AND CARE INSTRUCTIONSDo not submerge in water Measuring Temperatures SPECIFICATIONSBatteries-Alkaline recommended Temperature checkFCC ID OMO-01RX Receiver OMO-01TX transmitter WARRANTY INFORMATION1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE 2002 Oreck Holdings, LLC. All rights reserved
Top Page Image Contents