Oreck WS-7013U instruction manual B. Indoor Temperature Station

Page 7

B. INDOOR TEMPERATURE STATION

B. INDOOR TEMPERATURE STATION

Note: After the batteries are installed, DO NOT press any buttons. This may interfere with the signals, causing temperatures to register incorrectly.

Battery

Cover

1.Remove the battery cover on the backside. To do this, push the cover upward and pull it out.

2.Observing the correct polarity, install

(2) AAA batteries.

3.Replace the battery cover.

4.Wait 10 minutes or until both the indoor and outdoor temperatures are shown on the indoor temperature station.

6

Image 7

Contents Register your product on the web at WS-7013U Wireless 433 MHz Temperature Station Instruction ManualTopic TABLE OF CONTENTSDetailed Setup Guide Features1. The indoor temperature station Figure INVENTORY OF CONTENTSADDITIONAL EQUIPMENT 5. Instruction Manual and Warranty Card 6. 2 AAA 1.5V batteriesThe remote temperature sensor has a range of QUICK SETUP2. Batteries should be out of both units for 10 minutes 4. DO NOT PRESS ANY BUTTONS FOR 10 MINUTES80 feet in a straight line I. BATTERY INSTALLATION A. REMOTE TEMPERATURE SENSOR Press and release the SET button once more to complete the setupDETAILED SETUP GUIDE B. INDOOR TEMPERATURE STATION II. TIME A. SETTING THE TIME 4. Press and release the MIN/MAX button to set the hour B. RESETTING THE MINIMUM AND MAXIMUM TEMPERATURES IV. FEATURES A. MINIMUM AND MAXIMUM TEMPERATURESV. MOUNTING A. REMOTE TEMPERATURE SENSOR TROUBLESHOOTINGB. THE TEMPERATURE STATION Solution Opening the casings voids the warranty. Do not try to repair the unit MAINTENANCE AND CARE INSTRUCTIONSDo not submerge in water Temperature check SPECIFICATIONSMeasuring Temperatures Batteries-Alkaline recommendedFCC ID OMO-01RX Receiver OMO-01TX transmitter WARRANTY INFORMATION1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE 2002 Oreck Holdings, LLC. All rights reserved