Oreck WS-7013U Inventory Of Contents, Additional Equipment, The indoor temperature station Figure

Page 3
INVENTORY OF CONTENTS

INVENTORY OF CONTENTS

1.The indoor temperature station (Figure 1)

2.The remote temperature sensor (TX6U) and mounting bracket (Figure 2)

3.(3) 1/2" Philips screws

4.One strip of double sided adhesive tape

5.Instruction Manual and Warranty Card

6.(2) AAA 1.5V batteries

7.(2) AAA 1.5V batteries

Figure 1

Figure 2

ADDITIONAL EQUIPMENT

1.Philips screwdriver (not included) 2

Image 3
Contents Register your product on the web at WS-7013U Wireless 433 MHz Temperature Station Instruction ManualTopic TABLE OF CONTENTSDetailed Setup Guide Features1. The indoor temperature station Figure INVENTORY OF CONTENTSADDITIONAL EQUIPMENT 5. Instruction Manual and Warranty Card 6. 2 AAA 1.5V batteriesThe remote temperature sensor has a range of QUICK SETUP2. Batteries should be out of both units for 10 minutes 4. DO NOT PRESS ANY BUTTONS FOR 10 MINUTES80 feet in a straight line Press and release the SET button once more to complete the setup I. BATTERY INSTALLATION A. REMOTE TEMPERATURE SENSORDETAILED SETUP GUIDE B. INDOOR TEMPERATURE STATION II. TIME A. SETTING THE TIME 4. Press and release the MIN/MAX button to set the hour IV. FEATURES A. MINIMUM AND MAXIMUM TEMPERATURES B. RESETTING THE MINIMUM AND MAXIMUM TEMPERATURESV. MOUNTING TROUBLESHOOTING A. REMOTE TEMPERATURE SENSORB. THE TEMPERATURE STATION Solution MAINTENANCE AND CARE INSTRUCTIONS Opening the casings voids the warranty. Do not try to repair the unitDo not submerge in water Temperature check SPECIFICATIONSMeasuring Temperatures Batteries-Alkaline recommendedWARRANTY INFORMATION FCC ID OMO-01RX Receiver OMO-01TX transmitter1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE 2002 Oreck Holdings, LLC. All rights reserved