Scag Power Equipment SVR48V-24FX, SVR52V-26FX, SVR36A-20FX Engaging the Deck Drive Cutter Blades

Section 4 R

PULL BACK	NEUTRAL PUSH FOR
FOR REVERSE	FORWARD

“N” FOR NEUTRAL LOCK “D” FOR DRIVE

Figure 4-2. Forward / Reverse Controls

4.6ENGAGING THE DECK DRIVE (CUTTER BLADES)

1.Set the throttle at about 3/4 speed. Do not attempt to engage the deck drive at high speed as this shortens the electric clutch life — use only moderate engine speed when engaging the deck drive.

2.Engage the deck drive by pulling out on the yellow switch, located on the instrument panel, to the engage position. See Figure 4-2.

WHILE TRAVELING FORWARD, PULL BACK ON LEFT STEERING CONTROL TO STEER LEFT

WHILE TRAVELING FORWARD,PULL BACK

ON RIGHT STEERING CONTROL TO STEER RIGHT

Figure 4-3. Steering Controls

PULL UP TO ENGAGE

PUSH DOWN TO DISENGAGE

390S0138

Figure 4-4. Cutter Engage Switch

CAUTION

Disengage power to the mower before backing up. Do not mow in reverse unless absolutely necessary and then only after observation of the entire are behind the mower.

CAUTION

Before backing up, observe behind the mower for persons and obstructions. Clear the area before backing up. Possible injury or property damage could occur.

- NOTE -

A squealing noise may be heard when engaging or disengaging the deck drive. It is caused by the electric clutch plates meshing as the mower comes up to speed. This is normal.

13