R
Section 7
7.3 Hydraulic System
A. Checking Hydraulic Oil Level
The hydraulic oil level should be checked after the first 8 hours of operation. Thereafter, check the oil after every 200 hours of machine operation or monthly, whichever occurs first.
- IMPORTANT -
If the oil level is consistently low, check for leaks and correct immediately.
1.Wipe dirt and contaminants from around the reservoir cap. Remove the cap from the hydraulic oil reservoir.
2.Visually check the level of hydraulic oil. Hydraulic oil must be at least
3.Clean the fill cap and install it onto the reservoir.
HYDRAULIC OIL
RESERVOIR
Figure 7-2. Hydraulic Oil Reservoir
B. Changing Hydraulic Oil
The hydraulic oil should be changed after every 500 hours or annually, whichever occurs first. The oil should also be changed if the color of the fluid has become black or milky. A black color and/or a rancid odor usually indicates possible overheating of the oil, and a milky color usually indicates water in the hydraulic oil.
- IMPORTANT -
The hydraulic oil should be changed if you notice the presence of water or a rancid odor to the hydraulic oil.
1.Park the mower on a level surface, stop the engine and remove the ignition key.
2.Place a suitable container under the hydraulic oil filter. Remove the fill cap from the reservoir. Remove the drain plug from the fitting on the filter base. See Figure
3.
- NOTE -
Before refilling the hydraulic oil reservoir the hydraulic oil filter should be changed as outlined in Procedure C "Changing Hydraulic Oil Filter Element".
4.Fill the reservoir to full
5.Replace the reservoir fill cap. Start the engine and drive forward and backward for two minutes. Check the oil level in the reservoir. If necessary, add oil to the reservoir.
32