Scag Power Equipment STT61V-31EFI-SS manual Lubrication

Section 7								R
MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)
			HOURS
							Procedure	Comments
	Break-In	8	40	100	200	500
	(First 10)
					X		Apply grease to fittings	See paragraph 7.2
					X		Check hardware for tightness
					X		Change engine oil filter	See paragraph 7.4
					X		Check hydraulic oil level	See paragraph 7.3
						X	Replace engine fuel filter	See paragraph 7.5
						X	Drain hydraulic system and replace	Use SAE 20W50 Motor Oil.
							hydraulic oil	See paragraph 7.3
						X	Replace hydraulic oil filter	See paragraph 7.3

XReplace cutter deck gearbox See paragraph 7.11 lubricant

X Change coolant See paragraph 7.11

7.2 Lubrication

GREASE FITTING LUBRICATION CHART (SEE FIGURE 7-1)

	LOCATION	LUBRICATION INTERVAL		LUBRICANT	NO. OF
					PLACES
1	Caster Wheel Pivot *	500	Hours/Yearly	Chassis Grease	2
2	Caster Wheel Bearings	100	Hours/Monthly	Chassis Grease	2
3	Cutter Deck Bellcranks	100	Hours/Bi-Weekly	Chassis Grease	4
4	Cutter Deck Pusharms	100	Hours/Bi-Weekly	Chassis Grease	2
5	PTO Spindle	40 Hours/Weekly		+Lithium MP White Grease 2125	1
6	Cutter Deck Spindle	40 Hours/Weekly		+Lithium MP White Grease 2125	3
7	Brake Handle	200	Hours/Monthly	Chassis Grease	1
8	Cutter Deck Drive Shaft U-Joints	200	Hours/Monthly	Chassis Grease	2
9	Cutter Deck Drive Shaft Slip Sleeve	40 Hours/Weekly		Chassis Grease	1

+ Compatible Greases:	Mobilix #2 found at Mobil Service Stations
	Ronex MP found at Exxon Service Stations
	Super Lube MEP #2 & Super Stay-M #2 found at Conoco Stations
	Shell Alvania #2 found at Shell Service Stations
	Lidok EP #2 found at industrial shops
	Timken Lithium Multi-Use #2 found at industrial shops

*PROCEDURE: Remove grease cap, part number 481559. Remove plug, part number 482028-01, and install grease zerk. Apply grease to the fitting until new grease appears at the top of the caster extension. Remove the grease zerk and reinstall the plug. Reinstall the grease cap. Special tool, part number 47007, is recommended for use in the installation of the grease cap.

31