7. Operation
F6
F7
F8
F9
F10
WARNING
It is very dangerous to run a chainsaw that mounts broken parts or lacks any parts.
Before starting engine, make sure that all the parts including bar and chain are installed properly.
■STARTING ENGINE
1.Fill fuel and chain oil tanks respectively, and tighten the caps securely. (F6)
2.Put the switch to "I" position. (F7)
3.While holding the throttle lever together with the throttle interlock, push in the side latch and release the throttle lever to hold it at the starting position. (F8)
4.Pull out the choke knob to the closed position. (F9)
(1) | Chain oil | (2) | Fuel |
(3) | Switch | (4) | Throttle lever |
(5) | Throttle interlock | (6) | Latch |
(7) Choke knob
NOTE
When restarting immediately after stopping the engine, leave the choke knob at the open position.
5.While holding the saw unit securely on the ground, pull the starter rope vigorously. (F10)
WARNING
Do not start the engine while hanging the chain saw with a hand. The saw chain may touch your body. It's very dangerous.
6.When engine has ignited first, push in the choke knob and pull the starter again to start the engine.
7.Allow the engine to warm up with the throttle lever pulled slightly.
WARNING
Keep clear of the saw chain as it will start rotatIng upon starting of engine.
10