TProttle wire
io throttle lever
STEP 1
Throttle wre ano
Flcj 9
Mounting the handle and connecting the throttle wire and switch cords.
1klatch the protrusions on the handle joint 10 the slot in the underside of the handle and tighten h e four socket head bolts M 5 evenly to secure the handle (Fig 5,6)
2Connect the throttle wires and firmly close the cable joint (as shown in 3 steps in Fig 7 )
Note Squeeze the throttle lever to make sure that the throttle wire moves smoothly
3Connect the switch cords to the two cords from the engine by inserting one into the other
4Wrap the waist pad around the drive shaft so tnat the hanger will protrude through the slit in the waist pad and the throttle wire and cords w1'I also be wrapped under the waist pad (Fig 8 )
5Secure the throttle wire with the w e clip as shown in the figure for easy oDeratioi1 (Fig 9)
6Cover the throttle wire and swtct?cords w t h split tubing (Fig 10)
Notes It IS easier to instdl ihe split tcrbing if the bullet connectors are partially pished into the motor cover to rernove sixk fiom the wires
6