Makita RBC253, RBC252 instruction manual Refueling

Page 9

REFUELING

Use Oil-gasoline mixture for fuel as noted in "Fuel and Oil Mixture" on previous page

Always shut off the engine and allow it to cool before refuel- ing.

Thoroughly clean the area around the fuel filter cap, to pre- vent dirt from getting into the fuel tank.

Unscrew the fuel cap and fill the tank with fuel, then screw on the fuel filler cap tightly(EdT. /'3,'- ..I

Wipe off any spilled fuel before starting. and check for leak- age

Check for fuel leakage while refueling and during operation If fuel or oil leakage is found, do not start or run the engine until the leak is fixed and any spilled fuel has been wiped away.

Avoid skin contact with mineral oil products. Do not inhale fuel vapor. Always wear protective gloves during refueling. Change and clean protective clothing at regular intervals.

Take care not to spill either fuel oi oil in order to prevent soil contamination (environmentalprotection) Clean the brush cutter or string trimmer immediately after fuel has been spilt

Avoid any fuel contact with your clothing. Change your cloth- ing instantly if fuel has been spilt on it (a danger to life)

Inspect the fuel cap at regular intervals making sure that it I S securely tightened.

Select bare ground for fueling and move at least 10 feet (3m) from fueling spot before starting the engine(Fy, &),

Never refuel in closed rooms. Fuel vapors accumulate at ground level (risk of explosions).

Only transport and store fuel in a container approved for gasoline. Make sure the stored fuel is not accessible to chil- dren.

WARNING!

Gasoline is extremely flammable fuel Use extreme caution when handling gasoline or fuel mix. Do not smoke or bring any fire or flame near the fuel(FA?. /yI4

1

Figl 5

1

Figl 6

Figl 7

= .

9

Image 9
Contents Read i uies for operation z-irldinstrucirons carefully Brush CutterSafety Rules and Precautions Page TTaT&ip Equipment DescriptionString Trimmer Model RBC253 Io throttle lever Mounting the protector Fig Assembly Instructions forDo not MIX Gasoline a N D OIL Directly in the Fuel Tank Preparing for OperationRefueling Procedures Death Correct Handling of the MachineHandling the machine Idle adjustmentDAlLY CHECK-UP and Maintenance Storage Instructions for USE of the Cutter Blade Safety instructionsMaintenance instructions Kickback PreventionStar Blade Bump & Feed BF4 Instructions for USE of the Nylon Cutting Head Model WBC253Replacing the nylon cord Bump & Feed BF4 He notch into the other side of the spool. Allow oneOwners Warranty Responsibilities Manufacturers Warranty CoverageWarranty Period LllMlTED Warranty California OnlyWhat is not Covered Under this Warranty HOW to File a Warranty Claim Where to GET Warranty Services