Makita RBC252 Preparing for Operation, Do not MIX Gasoline a N D OIL Directly in the Fuel Tank

Page 8

PREPARING FOR OPERATION

Fuel and oil mixture

This product is powered by a two-cycle engine and requires pre-mixing gasoline and two-cycle engine 011

Inspect the fuel tank and fill with clean, fresh fueland oil of

the proper rrtxture to assure the longer life of the

tool Use the following mixed gas

 

 

 

Gasoline Genuine Makita Two-cycle engine oil = 50 1 or

 

 

Gasoline Other manufacturer's Two-cycle engine oil = 25 1 recommended

 

____- - __

- - .

~

____

-.

FOR CALIFORNIA REGULATION:

THIS EQUIPMENT IS CERTIFIED TO OPERATE ON GASOLINE + TWO-CYCLE ENGINE OIL

WHEN MIXING GASOLINE WITH TWO-CYCLE ENGINE OIL,USE ONLY GASOLINE WHICH CONTAINS NO ETHANOL OR METHANOL (TYPES OF ALCOHOL). THIS WILL HELP TO AVOID POSSIBLE DAMAGE TO ENGINE FUEL LINES AND OTHER ENGINE PARTS.

DO NOT MIX GASOLINE A N D OIL DIRECTLY IN THE FUEL TANK.

IMPORTANT: Failure to follow groper fuel mix instructions may cause damage to the engine.

CAUTION:

1 . When preparing fuel mixture, mix only the amount needed for the job you are to do. Do not use fuel mixture that has been stored longer than tbvo months. Fuel mixture stored longer than this will cause hard starting and poor performance, If fuel mix has been stored longer than this time, it should be removed and replaced with a fresh mixture.

2. Never-f i l l the fuel tank to the very top

3.Never add fuelto the tank in a closed, unventilated area.

4Do no: add fuel to this unit close to an open fire or sparks

5. Be sure to wipe off spilled fuel before attempting to start the engine

6.Do not attempt to refuel a hot engine.

Check points before operation

1 . Check for loose bolts, nuts and fittings.

2.Check the air cleaner for dirt. Clean the air filter of all dirt, etc. before operation

3.Check to be sure that protector is securely in place.

Image 8
Contents Brush Cutter Read i uies for operation z-irldinstrucirons carefullySafety Rules and Precautions Page Equipment Description TTaT&ipString Trimmer Model RBC253 Io throttle lever Assembly Instructions for Mounting the protector FigPreparing for Operation Do not MIX Gasoline a N D OIL Directly in the Fuel TankRefueling Procedures Correct Handling of the Machine DeathIdle adjustment Handling the machineDAlLY CHECK-UP and Maintenance Storage Safety instructions Instructions for USE of the Cutter BladeStar Blade Maintenance instructionsKickback Prevention Instructions for USE of the Nylon Cutting Head Model WBC253 Bump & Feed BF4He notch into the other side of the spool. Allow one Replacing the nylon cord Bump & Feed BF4Manufacturers Warranty Coverage Owners Warranty ResponsibilitiesLllMlTED Warranty California Only Warranty PeriodWhat is not Covered Under this Warranty HOW to File a Warranty Claim Where to GET Warranty Services