Makita RBC253, RBC252 instruction manual Assembly Instructions for, Mounting the protector Fig

Page 7

ASSEMBLY INSTRUCTIONS FOR

BRUSH CUTTER (ModelRBC252)

Mounting the protector (Fig. 11)

1. Install the clamp on the drive shaft so that the

projection of the clamp is inserted into the opening between the gear case and the drive shaft.

2.Attach the protector with two installation bolts M6x20.

Mounting the cutter blade (Fig. 12,13)

1. Turn the machine upside down so that you can easily install the cutter blade.

2.Insert the hex wrench through the hole in the back of the gear case and turn the tightening washer until it is locked with the hex wrench (or the shaft is locked).

3. Using the socket wrench, remove the left-handed

nut (by turning it clockwise). Also remove the tightening washer.

4.Mount the cutter blade onto the shaft so that the guide of the support washer fits in the arbor hole in the cutter blade. Install the tightening washer and secure the cutter blade with the nut.

(Tightening torque: 130-230Kg-cm,l 15-200in-

Ibs).

NOTE:

Always wear gloves when handling the cutter blade.

WARNING:

The cutter blade should be installed firmly a n d securely. (Fig. 14)

If the guide of the support washer doesn't fit in the arbor hole in the cutter blade. the brush cutter will make violent vibration. It not only shortens the machine life, but may also allow the cutter blade t o loosen and fly off.

Failure to install the blade correctly can c a u s e serious injury.

7.

!FA PO RTANT!

READ THE INSTRUCTIONSFOR USE O F THE B R U S H C U T T E R B L A D E (PAGE 15) BEFOFIE O F E R A T I N G T H I S MACHINE .

Gear case

Installation bolt M6x20

Protector

Fig. 11

r-- ~

I

H E

Image 7
Contents Read i uies for operation z-irldinstrucirons carefully Brush CutterSafety Rules and Precautions Page TTaT&ip Equipment DescriptionString Trimmer Model RBC253 Io throttle lever Mounting the protector Fig Assembly Instructions forDo not MIX Gasoline a N D OIL Directly in the Fuel Tank Preparing for OperationRefueling Procedures Death Correct Handling of the MachineHandling the machine Idle adjustmentDAlLY CHECK-UP and Maintenance Storage Instructions for USE of the Cutter Blade Safety instructionsKickback Prevention Maintenance instructionsStar Blade Bump & Feed BF4 Instructions for USE of the Nylon Cutting Head Model WBC253Replacing the nylon cord Bump & Feed BF4 He notch into the other side of the spool. Allow oneOwners Warranty Responsibilities Manufacturers Warranty CoverageWarranty Period LllMlTED Warranty California OnlyWhat is not Covered Under this Warranty HOW to File a Warranty Claim Where to GET Warranty Services