CD Player Operation

CDX6311

Insert CD

Press the EJECT button (22) and the front panel will slide down to display the disc slot. With the label surface facing up, fully insert a compact disc into the slot until the mechanism engages and pulls the disc in. After inserting a disc, press in and up along the bottom edge of the front panel to push the front panel back into the closed position.

Eject CD

Press the EJECT button (22) and the front panel will slide down to display the disc slot.

Press the second eject button (27) to stop CD play and eject the disc. The unit will change to tuner, CD changer or XM operation, depending on which mode was in operation prior to disc play. If the disc is not removed from the unit within 15 seconds, the disc will be reloaded to prevent accidental damage.

NOTE: The unit is designed for play of standard 5” (12 cm.) compact discs only. Do not attempt to use 3” (8 cm.) CD singles in this unit, either with or without an adaptor, as damage to the player and/or the disc may occur. Such damage will not be covered by the warranty on this product.

Pause

Press the pause button (12) to suspend disc play. Press the pause button again to resume disc play.

Track Select

Press the UP TUNING (10) or DOWN TUNING (11) button for less than one second to advance to the next track on the CD. The selected track number will appear on the display. Press and hold the UP TUNING (10) or DOWN TUNING (11) button for more than one second to fast forward or fast reverse through the disc. CD play starts when the button is released.

Intro Scan (SCN)

During disc play, press SCN (13) to play the first 10 seconds of each track on the disc. When the desired track is reached, press SCN again to end the scan and play the selected track.

Repeat (RPT)

Press RPT (14) during disc play to continuously repeat the track. Press RPT again to stop repeating.

Random (RDM)

Press RDM (15) during disc play to play all tracks on a CD in random, shuffled order. Press RDM again to stop random play.

Display CD Text

Press AS/PS (21) to display any text encoded on the CD (song title, artist, etc.).

CD Player Error Codes

If a problem should develop while operating the CD player, an error code (ER-1, ER-2, etc.) may appear on the display panel. This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor control of the player. If an error code should appear, try ejecting and reloading the disc into the player. While the disc is out of the unit, make sure it is clean and undamaged, and then load it correctly. If this does not solve the problem, pressing the reset button may help, but will erase the time and preset memory. If the suggested measures do not solve the problem, contact an approved warranty station near you or contact customer service at 1-800-323-4815 for further assistance.