Poulan 530164256 Carton Contents, Tools Required, Installing Brushcutter Attachment

otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An anti--vibration system does not guarantee the avoidance of these problems. Users who oper- ate power tools on a continual and regular basis must monitor closely their physical condition

and the condition of this tool.

SPECIAL NOTICE: This unit is equipped with a temperature limiting muffler and spark arresting screen which meets the require- ments of California Codes 4442 and 4443. All

U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Ore- gon, and Washington require by law that many internal combustion engines be equippedwith a spark arresting screen. If you operatein a locale where such regulations ex- ist, you are legally responsible for maintaining the operating condition of these parts. Failure to do so is a violation of the law. For normal homeowner use, the muffler and spark arrest- ing screen will not require any service. After 50 hours of use, we recommend that your muffler be serviced or replaced by your autho- rized service dealer.

CARTON CONTENTS

Check carton contents against the following list:

Coupler

LOOSEN

SPowerhead

SLower attachment (with trimmer head

installed)

SCupped washer

S	Large nut for installing blades
S	Hex wrench
S	Handlebar
S	Bracket cover
	Bracket cover screws (2)

Shipping protector

TIGHTEN

Knob

S	Metal blade shield
S
S	Blade shield screws (4)
S	4--point weed blade
S	Plastic shield
S	Wing nut (screwed onto plastic shield)
S	Shoulder strap with warning
S	Container of oil

WARNING: Always stop unit anddis- connect spark plug before performing any as- sembly procedures.

WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.

Examine parts for damage. Do not use dam- aged parts.

NOTE: If you need assistance or find parts missing or damaged, call 1-800-554-6723.

It is normal for the fuel filter to rattle in the empty fuel tank.

Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.

TOOLS REQUIRED

SHex wrench (provided) S Adjustable wrench

S Phillips screwdriver

INSTALLING BRUSHCUTTER ATTACHMENT

CAUTION: When installing brushcutter at- tachment, place the unit on a flat surface for stability.

1.Loosen the coupler by turning the knob counterclockwise.

2.Remove shipping protector from coupler.

3.Remove the shaft cap from the brushcutter attachment (if present).

4.Position locking/release button of attach- ment into guide recess of coupler.

5.Push the attachment into the coupler until the locking/release button snaps into the primary hole.

6.Before using the unit, tighten the knob se- curely by turning clockwise.

Coupler	Primary Hole
		Guide Recess
Upper	Locking/	Lower
	Release
Shaft		Attachment
	Button

WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. All attachments are designed to be used in the primary hole.

For optional attachments, see the AS- SEMBLY section of the applicable attach- ment instruction manual.

ATTACHING THE HANDLEBAR

DANGER: To avoid serious injury, the barrier portion of the handlebar must be installed as shown to provide a barrier between operator and the spinning blade.

1.Locate the decal on the handlebar. This decal includes an arrow. Position the handlebar with the mounting bracket at the end of the arrow.

4