Husqvarna 80792 manual Midget Manual and High Profile Trimmer Heads

INSTALLATION INSTRUCTIONS

Midget Manual and High Profile Trimmer Heads

Midget Manual

High Profile

NOTE: Operating with trimmer line of uneven length will cause excessive vibration. Always make sure the line is wound evenly and trimmed to equal lengths from the eyelets.

72414-15100*

Fits F18, F21, F230

72086-15100

Fits LT18, T18, T20, C20, LT20, T230, C230, 22T

72031-15100

F20

72005-92600

Fits T25, C25, T27, C27, BP35, T250, C250, T260, C260, T270, C270, T350

99909-151

Fits C35, B45, RC45, C350, B450

Line Chart

Midget Manual 72414-15100 72086-15100 72031-15100 Shipped with 14 feet of .080 line.

Maximum fill– 26 feet of .080 6 feet of .095

High Profile 72005-92600 99909-151

Shipped with 21 feet of .095 line.

Maximum fill– 26 feet of .095 20 feet of .105

1 2 3

Remove the wing nut knob and spring Remove the line spool. (turn counterclockwise to remove on

72414-15100; turn clockwise on all others).

Clean the spool, housing and eyelets. Inspect for wear and damage, and replace damaged components.

4 5 6

Reattach the eyelets (if they were removed). Never run a trimmer head without eyelets!

Replace the line by threading through the eyelet in the spool until the line ends are of equal length. Refer to the Line Chart (above) for the proper amount of line.

Bend the line at spool eyelet to form two lengths. 72414-15100:Wind both ends clockwise as viewed from the underside of the head. All others: Wind counterclockwise.

12