To advance line: With the engine off, loosen the bottom knob a few turns in the direction of rotation. Grasp the trimmer head in both hands. Rotate the bottom of the spool clockwise and pull the line through the eyelets.
7 | 8 | PARTS LIST |
1 Adapter Bolt
2 Outer Housing
Use your finger to separate the line | Holding the spool and wound line |
into two sections. Doing so will assist | in one hand, place the lines 180 |
in a smooth line feed when the head | degrees apart. |
is reassembled. |
|
9 | 10 |
3Inner Spool
4Eyelets
5Spring
6Button/Knob
Hold the spool over the housing and feed one line end into an eyelet. As you place the spool in the head, feed the other line into the opposite eyelet.
Make sure one line does not slide under the spool.
11
Reinstall the spring and knob. Tighten securely.
Tip: Sometimes it’s easier to remove one eyelet to install the second piece of line. Slide the eyelet over the line two to three inches, then push the eyelet in place as the spool is re- placed in the housing.
12
1" to 2"
A properly wound and reassembled head should have four or five inches of line extending from each eyelet and the overlap should be one to two inches. Trim as needed to final length.
Low Profile Head
72036-15200 Item Part No.
1
2
3*
4
5
6
Item | Part No. |
1
2
3*
4
5
6
Item | Part No. |
1
2
3*
4
5
6
*2 required
5