INSTALLATION INSTRUCTIONS
Low Profile Manual Trimmer Head
Model View
Fits LT18, T18, T20, C20, LT20, T230, C230, 22T
Fits F20, T25, C25, T27, C27, BP35, T250, C250, T270, C270, T260, C260, T350
Fits C35, C350, RC45, B45, B450
NOTE: Operating with trimmer line of uneven length will cause excessive vibration. Always make sure the line is wound evenly and trimmed to equal lengths from the eyelets.
Line Chart
20 feet of .080 line.
Maximum fill– 40 feet of .080 30 feet of .095 26 feet of .105
1 | 2 | 3 |
Remove the knob and spring (turn | Remove the line spool. | Clean the spool, housing and eyelets. |
counterclockwise to remove). |
| Inspect for wear and damage. |
|
| Replace damaged components. |
4 | 5 | 6 |
Reattach the eyelets if they were removed. Never operate a trimmer head head without eyelets!
Replace the line by threading it through the eyelet in the spool until the line ends are of about equal length. Refer to the Line Chart (above) for the proper amount of line.
Bend the line at the eyelet to form two lengths. Wind both ends clockwise as viewed from the underside of the head.
4