7
8 | PARTS LIST |
Lock the ends of line into line saver slots in spool.
9
Insert the spring onto the bolt. With the line saver slots on the spool facing the bolt, thread the ends of the line into the eyelets in the housing. Do not allow the line to go under the spool.
10
2 Eyelet
1 Outer Housing
3 Adapter Bolt
4 Spring
5 Inner Spool
6 Button/Knob
7 Outer Cover
|
|
| ||
|
|
| ||
Item | Part No. |
| Item | Part No. |
Place the button in the center of`the spool.
11
1" to 2"
Replace the cover by aligning the tabs and then twisting counterclockwise as viewed from the button side of the head
12
1
2*
3
4
5
6
7
Item | Part No. |
1
2*
3
4
1
2*
3
4
5
6
7
Item | Part No. |
5
6
7
Check for a maximum line overlap of one to two inches (four to five inches of line extending from each eyelet).
Trim as required to final length.
Bump ‘N’ Cut |
| |||
| ||||
Item | Part No. |
| Item | Part No. |
1 | 1 | |||
2* | 2 | |||
3 | 3 | |||
4 | 4 | |||
5 | 5 | |||
6 | 6 | |||
7 | 7 | |||
*2 required
15