ASSEMBLY
Fitting the hand guard and loop handle
(327HDA65, 327HE3)
1Assemble the hand guard and loop handle by screwing them together. Take care to align the holes in both parts. (327HDA65)
2Slide the loop handle and hand guard onto the shaft.
(327HDA65)
3Slide the spacer into the slot in the loop handle.
4Fit the nut and screw. Do not overtighten.
5Now make a final adjustment to give yourself a comfortable working position. Tighten the screw. CAUTION! The loop handle and hand guard must not be fitted behind the arrow marked on the shaft.
Fitting the handle
(327HE3, 327HE4)
Fit the handle using two screws.
Fitting the cutting head
(327HDA65)
It is important that the hedge trimmer is laid on a flat surface when you fit the cutting head. Otherwise the cutting head may not be fitted straight.
1Fit the cutting head to the shaft. CAUTION! Make sure the drive shaft inside the shaft engages with the recess in the cutting head.
2Tighten the lower screw first, then the upper screw.
10 – English