Husqvarna 327HDA65X, 327HE3X, 327HE4X manual Adjusting the harness, Fitting the impact guard

Page 11

ASSEMBLY

Adjusting the harness

(327HE4)

You should always use the harness with the machine to give maximum control over the machine and reduce the risk of fatigue in your arms and back.

1Put on the harness.

2Hook the machine onto the harness support hook.

3Adjust the length of the harness so that the support hook is roughly level with your right hip.

Fitting the impact guard

(327HE4)

Fit the guard using the three screws and washers. Fit the two short screws in hole A. Tighten the screws to a torque of 4 Nm. After the machine has been in use for around 20 hours, re-tighten the screws to 4 Nm.

English – 11

Image 11

Contents English 327HDA65X-seriesSymbols KEY to SymbolsContents Dear Customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentMufﬂer Stop switchHand guard Vibration damping system327HDA65 Gear housingBlades Blade guardFitting the cutting head AssemblyFitting the hand guard and loop handle Fitting the handle327HE4 Adjusting the harnessFitting the impact guard Fuel Fuel safetyFuel Handling Mixing FuellingStarting Starting and StoppingCheck before starting Starting and stoppingStopping General working instructions Safety instructions regarding the surroundingsSafety instructions while working Working TechniquesChanging the hedge trimmer angle Safety instructions after completing workBasic working techniques Transport position Mufﬂer MaintenanceCarburettor Spark plug Cooling systemOiling the air ﬁlter Gear housingCleaning the air ﬁlter Air ﬁlterCleaning and lubrication Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataEC-declaration of conformity Applies to Europe only Page Page 1151377-26